Freedom Que Dining Table 1800-900 Veneer and Hi Gloss Assembly Instruction

Assembly Instructions

Que Dining Table 180 x 90cm (Veneer and High Gloss Tops)

Before you begin to assemble your new piece of furniture, please check to ensure that all parts have been supplied.

Follow instructions closely as deviation from them may void your warranty and present a possible safety risk.

It is recommended that assembly is done on a soft surface like carpet to avoid any damage.

If you experience any problems with your new purchase please phone Freedom Customer Service (FCS) on 1300 135 588
(Customers outside Australia should contact their closest Freedom store.)

Care Information

Periodically check and re-tighten all fasteners. Wipe down all surfaces using a clean cloth. For Timber Veneer tops, dust weekly
with a clean cloth. Use a Freedom recommended polish every three months. For Hi - Gloss tops, wipe down using a clean cloth.

Assembly Information

The table top is affixed to the base using screws. A screwdriver is required to fasten them. Should you not feel comfortable
fastening the top yourself, please contact your nearest Freedom store to arrange assembly at an additional charge.

Hardware

16 x Part A 16 x Part B 4 x Part C

(Affixed to Part I)

Tools

1 x Part G

(Supplied)

Parts

4 x Part I

4 x Part J

(Affixed to Part I)

1 x Part H

(Supplied)

4 x Part D

2 x Part K

4 x Part E

(Affixed to Part I)

Required: 1 x Phillips Head

Screwdriver

4 x Part L

4 x Part F

rev 11.12.08
Page 1

1 x Part M 2 x Part N 2 x Part O

(Marble Tops only. Not required

16 x Part P

for Timber Veneer or Hi - Gloss

Table -Top)

Step 1.

Assembly Instructions

Que Dining Table 180 x 90cm (Veneer and High Gloss Tops)

Part J

Step 2.

Part N

Part H

x 2

Part J

x 2

Page 2

Part A

Step 3.

Assembly Instructions

Que Dining Table 180 x 90cm (Veneer and High Gloss Tops)

Part K

Part O

Step 4.

Part K

Part H

Part A

Page 3

Step 5.

T

R

!

Assembly Instructions

Que Dining Table 180 x 90cm (Veneer and High Gloss Tops)

Ensure that the top (Part
M) is square with the base
on all four sides and the
overhang of the top is even.

Step 6.

Use a screwdriver to fasten the
first 4 screws (part B) in the order
shown (1 - 4). Ensure base or top

!

do not move out of alignment
during this step.

2

Part B

4

1

3

Page 4

Step 7.

Assembly Instructions

Que Dining Table 180 x 90cm (Veneer and High Gloss Tops)

Part I

Step 8.

Part L

Page 5

Step 9.

Part G

Assembly Instructions

Que Dining Table 180 x 90cm (Veneer and High Gloss Tops)

Part F

Part C

Part D

Part E

Assembly is complete

Page 6