Franke FCUH52XSAU, FCUH90XSAU Instruction Manual

Page 1
Rangehood
Instruction Manual
FCUH52XSAU
FCUH90XSAU
Page 2
Content
1…………………………………..………………………………Safety instructions
2…………………………………..………………………………Installation
4…………………………………..………………………………Troubleshooting
5…………………………………..………………………………Maintenance and cleaning
6…………………………………..………………………………Environment protection
2
Page 3
SAFETY INSTRUCTIONS
This manual explains the proper installation and use of your rangehood,
please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference.
Never to do:
Do not try to use the rangehood
without the grease filters or if the filters are excessively greasy!
Do not install abov
high level grill.
Do not leave frying pans unattended
during use because overheated fats or oils might catch fire.
Never leave naked flames under the
rangehood.
If the rangehood is da
attempt to use.
Do not flambé under the rangehood.
CAUTION: Accessible parts may
become hot when used with cooking appliances.
The minimum distance between the
supporting surface for the cooking vessels on the cooktop and the lowest part of the rangehood. (When the rangehood is located above a gas appliance, this distance shall be at least 65 cm)
The air must not be discharged into a
flue that is used for exhausting fumes from appliances burning gas or other fuels.
e a cooker with a
maged, do not
Always to do:
Important! Always switch off the
electricity supply at the mains installation and maintenance such as light bulb replacement.
The rangehood must be installed in
accordance with the installation instructions and all measurements followed.
All installation work must be carried out
by a competent person or qualified electrician.
Please dispose of the packing material
carefully. Children are vulnerable to it.
Pay attention to the sharp edges
inside the rangehood especially during installation and cleaning.
Make sure the ducting has no bends
sharper than 90 degrees as this will reduce the efficiency of the rangehood.
Warning: Failure to install the screws
or fixing device in accordance with these instructions may result in electrical hazards
Warning: Before obtaining access to
terminals, all supply circuits must be disconnected.
during
3
Page 4
Always to do:
Always to do:
Always put lids on pots and pans
when cooking
When in extraction mode, air in the
room is being removed by the rangehood. Please make sure that proper ventilation measures are being observed. The rangehood removes odours from room but not steam.
Rangehood is for domestic use only.
If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
This appliance can be used by
children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Warning: Before obtaining access to
terminals, all supply circuits must be disconnected.
on a gas cooktop.
Caution: The appliance and its
accessible parts c during operation. Be careful to avoid touching the heating elements. Children younger than 8 years old should stay away unless they are under permanent supervision.
There shall be adequate ventilation of
the room when the rangehood is used at the same time as appliances burning gas or other fuels.
There is a fire risk if cleaning is not
carried out in accordance with the instructions
Regulations concerning the discharge
of air have to be fulfilled.
Clean your appliance periodically by
following the method given in the chapter MAINTENANCE.
For safety reason, please use only the
same size of fixing or mounting screw which are recommended in this instruction manual.
Regarding the details about the
method and frequency of cleaning, please refer to maintenance and cleaning section in the instruction manual.
Cleaning and user maintenance shall
not be made by children without supervision.
When the rangehood and appliances
supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
WARNING: Danger of fire: do not store
items on the cooking surfaces.
A steam cleaner is not to be used.
NEVER try to extinguish a fire with
water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.
an become hot
4
Page 5
INSTALLATION (VENT OUTSIDE)
MOUNTING OF THE V-FLAP
If the rangehood does not have an assembled V-flap 1, you should mount the half­parts to its body. The images only show an example of how to mount the V-flap,the outlet may be various according to different models and To mount the V-flap 1 you should:
mount two half-parts 2 into the body 6
• a pin 3 should be top oriented;
• the axis 4 should be inserted in the holes 5 on body;
• repeat all the operations for the 2nd half-part
configuration.
INSTALLATION
If you have an outlet to the outside, your rangehood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or non­flammable material with an interior diameter of 150mm)
1. Before installation, turn the unit off and unplug it from the outlet.
2. The rangehood should be placed at a distance of 65~75cm above the cooking surface for best effect.
5
Page 6
3. Cut a hole in the cupboard according to the size in pic below.Make sure the distance between the edge of the hole and the edge of the cupboard edge is at least 35mm.
For 52cm For 90cm
4. Remove the aluminum filter and remove the two front panel screws.
5. Use a screwdriver to secure the screws to the cabinet.
6. Replace the front panel with the two screws and replace the filter.
Note:The expansion pipe is not supplied
6
Page 7
WARNING:  For safety reason, please use only the same
size of fixing or mounting screw which are recommended in this instruction manual.
Failure to install the screws or fixing device in
accordance with these instructions may result in electrical hazards.
Start Using Your Rangehood
Toggle switch
There are 3 speeds for the motor and on off switch for the lamp.
1.Lamp – Turn on/off light
O” – to switch off lightI” – to switch on light
Power – Slide out drawer, power on; slide in drawer, power off. 2 .Speed –select speed to suit cooking conditions
O” – to switch off motor Low( I )– light frying/boiling Medium( II ) – frying/wok cooking/heavy boiling High ( III ) – grilling, intensive frying and wok cooking Power – Slide out drawer, power on; slide in drawer, power off.
TROUBLESHOOTING
Fault Possible Cause Solution
Fan switch turned off Select a fan switch position.
Light on, but motor does not work
Light does not work, motor does not work
Fan switch failed Contact service center. Motor failed Contact service center.
House fuses blown Reset/Replace fuses. Power cord loose or
disconnected
Refit cord to power outlet. Switch power outlet on.
Oil leakage
One way valve and the outlet are not tightly sealed
7
Take down the one way valve and seal with sealant.
Page 8
Leakage from the connection of chimney and cover
Take chimney down and seal.
Lights not working Broken/Faulty globes
The distance between the
Insufficient suction
The rangehood inclines
rangehood and the gas top is too far
The fixing screw not tight enough
Replace globes as per this instruction.
Refit the rangehood to the correct distance.
Tighten the hanging screw and make it horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and
federal laws.Please contact the service centre if in any doubt before undertaking any of the above. Always disconnect the unit from the power sour when opening the unit.
MAINTENANCE AND CLEANING
Caution:
• Before maintenance or cleaning is carried out, the rangehood
should be disconnected from the main power supply. Ensure that the rangehood is switched off at the wall socket and the plug removed.
ce
• External surfaces are susceptible to
cleaning instructions to ensure the best possible result is achieved without damage.
scratches and abrasions, so please follow the
GENERAL
Cleaning and maintenance should be carried out with the appliance cold when cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
, especially
STAINLESS STEEL
The stainless steel must be cleaned regularly (e.g. weekly) to ensure long life expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly criss cross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning.
Important
Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or products containing abrasives,as this will affect the appliance appearance
8
Page 9
and potentially remove any printing of artwork on the control panel and will void manufacture'
s warranty.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minute in water with a grease-loosening detergent then brush it gently with a soft brush. Please do not apply (Leave to dry naturally out of direct sun light).
Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use rinse aid.
too much pressure to avoid damaging it.
INSTALLING GREASE MESH FILTERS
• To install filters, follow these four steps.
- Angle the filter into slots at the back of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed at three or six months according to your cooking habits.
installation procedure of activated carbon filter is as below.
The (1) The aluminum filter should be detached first. Press the lock and pull it
downward.
(2) Take out the carbon filter by rotating the carbon filter anti-clockwise. (3) Replace the new carbon filter.
NOTE:
Make sure the filter is securely locked. Otherwise, it can loosen and become
dangerous.
When the activated carbon filter is attached, the suction power will be lowered.
9
Page 10
Note: B
efore changing the lights, make sure that the appliance is switched off at the
power point and the plug removed from the powerpoint.
Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
Remove the grease filter.Use a tool or the hand to press the spring splinter of both sides of LED light to the
inside, until the light is pressed out.Then slightly pull the light connecting wire out and replace the lights.
Apply the reverse procedure to install the light back.
ILCOS D code for this lamp is: DBR-2/65-H-64
– LED modules– round lamp – Max wattage: 2×2 W
– Voltage range: AC 110-240V – Dimensions:
ENVIRONMENTAL PROTECTION:
This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2012/19/EU. It will then be recycled or dismantled to minimize impacts on the environment, electrical and electronic products are potentially dangerous for the environment and human health due to the presence of hazardous substances.For more information, please contact your local or regional authorities.
NOTE:
The following shows how to reduce total environmental impact (e.g. energy use) of the cooking process).
(1) Install the rangehood in a proper place where there is efficient ventilation. (2) Clean the rangehood regularly (3) Remember to switch off the rangehood light after cooking. (4) Remember to switch off the rangehood after cooking.
so as not to block the airway.
INFORMATION FOR DISMANTLING
Do not dismantle the appliance in a way which is not shown in the user manual. The appliance could not be dismantled by user. At the end of life, the appliance should not be disposed of with household waste. Check with you local a for recycling advice.
uthority or retainer
10
Loading...