Foster EP700HH, EP700H2BK, EP700HBK, EP700HL, EP700G Original Operation Instructions

By Appointment to

Her Majesty Queen Elizabeth II

Suppliers of Commercial Refrigeration

Foster Refrigerator, King’s Lynn

Call: [phone] Fax: [phone] Email: [e-mail]

www.fosterrefrigerator.co.uk

A Division of ITW Ltd

Foster Refrigerator

Oldmedow Road

King’s Lynn

Norfolk, PE30 4JU

United Kingdom

ISO 9001 ISO 14001

English

Original Operation Instructions

EcoPro G2

Cabinet & Counter Models

00-556483 August 2016 Issue 7 GB

Controller & Display - Versions FD1-11 & FD1-14

1

Single Cabinets

EP700F
EP700G
EP700H
EP700H2
EP700H2BK
EP700HBK
EP700HH
EP700HL
EP700HSTB
EP700HU
EP700HMH
EP700P
EP700W

EP700L
EP700L2
EP700L2BK
EP700LBK
EP700LL
EP700LSTB
EP700LU
EP700LHM

EP700M
EP700M2
EP700MU

G700G
G700H
G700L
G700M
G700W

Double Cabinets

EP1440G
EP1440H
EP1440H4

EP1440HSTB
EP1440HU

EP1440W

EP1440L
EP1440L4

EP1440LSTB
EP1440LU

EP1440M
EP1440M4
EP1440MU

G1440H
G1440L
G1440M

Broadway

EP820HU
EP820LU

Workout

EP820MW
EP820LW

Counters

EP1/2G
EP1/2H
EP1/2L
EP1/2M
EP1/2P

EP1/3G
EP1/3H
EP1/3L
EP1/3M
EP1/3P

EP1/4G
EP1/4H
EP1/4L
EP1/4M

EP2/2H

EP2/3H

Models Applicable to This Manual

GB

2

General Electrical Safety

Foster Refrigerator recommends that the equipment is electrically connected via a Residual Current Device; such
as a Residual Current Circuit Breaker (RCCB) type socket, or through a Residual Current Circuit Breaker with
Overload Protection (RCBO) supplied circuit.

Disposal Requirements

If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in accordance
with national laws and regulations.

Start-Up and Operation

After unpacking, clean and allow the cabinet or counter to stand for 2 hours before turning on (cleaning
directions supplied within this manual). Ensure the cabinet is situated on a rm, level surface away from both

hot and cold air sources, as this will affect its performance.

Vaporiser Tray (Dual Temperature Models Only)

On delivery, the tray is attached to the rear of the cabinet. Remove the two xing screws and slide the vaporiser
tray underneath the cabinet, into the two xed runners.

Bend the corner tabs of the tray upwards, then using the guide holes already in the cabinet secure the tray in
position with the two screws originally removed.
The heaters electrical connection to the cabinet will already be in place. Ensure the drain line pipe is angled in an
upright position to form an air lock.

Please make sure that when positioning a dual temperature model with an external vaporiser tray the tray does

not come into contact with any other surfaces.

Clearance (All models)

Make sure that a minimum clearance of 310mm above and 50mm around the cabinet or counter is available for
ventilation and effective operation.

Connect the unit to a suitable mains power outlet and turn the supply on. Please do not plug or unplug the unit
with wet hands.

The cabinet will energise briey showing followed by the power switch slowly pulsing with a blank display.

The unit is now in standby.

Standby

Pressing the power switch for 3 seconds will turn the unit on (the switch backlight is static and the display shows
the operating temperature) or into standby (the switch backlight pulses slowly on and off).

As the operating temperature has been preset no adjustments are required. Allow the cabinet to reach its normal/
set operating temperature before loading.

Important Note to the Installer:

Please ensure that this document is passed to the user as it contains
important guidelines on operation, loading, cleaning and general
maintenance and should be kept for reference.

GB

3

GB

Display Icons and Switches

(Some icons or switches are only visible during adjustment, when activated by parameters or through operation/

manual selection).

User Adjustment Mode

You are required to enter this mode to make any setup changes.
These include Set Point, Keypad Security and display of T1, 2 or 3 probe temperatures.

Press and immediately release after which the and switches will ash/pulse together.

Press to scroll through the following screens:

(Cabinet Version)

Keypad Lock Warning/ Alarm

Service Mode Temperature Setting

Compressor Function Defrost Function

Evaporator Fan Function Reduced Energy Mode

Data Download Switch Light Switch

Decrease Switch Increase Switch

Power Switch

(Counter Version)