Page 1
Icon
GU10 Trimless Downlight
FD04P-00/11
fossLED open construction fire rated glass fixtures feature a low profile for installation versatility and good air
circulation for improved lamp lifetime.
Fire Rated to 30 minutes, 60 minutes and 90 minutes when installed in ceilings of approved construction to
BS 476: Part 21:1987.
IP65 dust and moisture sealed from the front when installed correctly.
This fitting is compliant to Building regulations Part B, Part C and Part L.
(When used in conjunction with high efficiency LED lamps).
This product must be installed by a qualified electrician in accordance with instructions provided and in compliance
with recognised electrical and safety regulations relevant to the country it is being installed.
This product must not be used with non-LED lamps and installed with a max lamp wattage of 7W.
This product is for indoor use only.
Minimum clearance is 50mm above the installed fitting and should NOT be installed within 200mm of any joist.
This light fitting should be connected to a circuit with a 30mA RCD when fitted in a room containing a bath or shower.
Avoid the installation of cables in locations that would cause a hazard. Position cables away from areas where there
may be at risk of them being trapped, damaged or cut.
www.fossled.com
Page 2
80mm
39mm
106mm
DIMENSIONS:
Ø80mm
80mm
80mm
39mm
87mm
106mm106mm
106mm
39mm
When installed in conjunction with our ‘Insulation bracket’ (Sold Seprately) this product is suitable for coverage by
thermal and acoustic insulation e.g. loft insulation. Not suitable for blown insulation. Please ensure a max wattage of
7W when covering with insulation and utilising the insulation bracket.
MIN
150mm
MIN 200mm MIN 200mm
If installing without an insulation bracket please ensure any insulation is at a minimum distance of 150mm away from
the fixture / lamp and not covering it.
MIN
150mm
MIN 150mm
MIN 200mm
MIN 150mm
MIN 200mm
Page 2Icon FD04P Product Manual
Page 3
INSTALLATION:
1
Ensure mains power is turned OFF and cannot be
unexpectedly reconnected.
3
2
Ø80mm
For new installations use suitable cutting tools and
carefully cut the required hole.
Screw a minimum of 6 screws to the fixture to keep
it in place.
4
When wiring please ensure you have identified the
correct wiring from the circuit and ensure the connections
are tight and no loose strands have been left outside of
the connection block.
Plaster up to the plaster lip for a seamless finish.
Page 3Icon FD04P Product Manual
Page 4
5
Fit the LED bulb into the fixture, then twist and connect
your LED bulb.
Compliant to all applicable UKCA Directive requirements.
Fit the fixture into the ceiling by aligning the tabs and then
rotating the inner cup until tight.
0.5m
Compliant to all applicable EC Directive requirements.
Please do not dispose of along with household waste. Waste electrical products should only be recycled using a suitable
local recycling facility. Contact your local authority for recycling advice.
Do NOT directly mount this product on normally flammable surfaces.
The product should be mounted on non-combustible surfaces.
A minimum distance of 0.5 metres from lighted objects.
The power supply is double insulated and so does not require an Earth connection.
This product is suitable for use in living areas, Bathroom Zones 2 and outside zones.
Page 4Icon FD04P Product Manual
Loading...