• • Tool needed for assembly: Phillips Screwdriver
(not included).
• Use only with the included Power Wheels
®
12 Volt Lead-Acid Rechargeable Battery with
Built-in Thermal Fuse and a Power Wheels
®
12 Volt Charger with type 12V connector
(both included).
• Requires four "C" (LR14) alkaline batteries
(not included) for FM radio operation.
original sales receipt.
Tool needed for assembly: Phillips Screwdriver
(not included).
• Use only with the included Power Wheels
12 Volt Lead-Acid Rechargeable Battery with
Built-in Thermal Fuse and a Power Wheels
12 Volt Charger with type 12V connector
(both included).
• Requires four "C" (LR14) alkaline batteries
(not included) for FM radio operation.
®
®
Owner's Manual
with Assembly Instructions for
Models T6991, W0030, W0029
IMPORTANT INFORMATION
ELECTRICAL HAZARD
DANGER
• To prevent electric shock, do not immerse in water; wipe clean with a damp cloth.
WARNING
• Battery can fall out and injure a child if vehicle tips over. Always use battery retainer.
• PREVENT FIRE
- Never modify the electrical system. Alterations could cause a re resulting in
serious injury and could also ruin the electrical system.
- Use of the wrong type battery or charger could cause a re or explosion resulting
in serious injury.
- Use of Power Wheels
could cause overheating, re or explosion.
• The battery must be handled by adults only. The battery is heavy and contains
sulfuric acid (electrolyte). Dropping the battery could result in serious injury.
• Never allow children to charge the battery. Battery charging must be done
by adults only. A child could be injured by the electricity involved in charging
the battery.
• Read the safety instructions on the battery.
• Examine the battery, charger and their connectors for excessive wear or damage
each time you charge the battery. If damage or excessive wear is detected, do not
use the charger or the battery until you have replaced the worn or damaged part.
• HOT motors. Handle carefully.
®
components in products other than Power Wheels® vehicles
RIDING HAZARD
WARNING
• Prevent Injuries and Deaths
• Direct Adult Supervision Required.
• Never Ride at Night.
• Keep Children Within Safe Riding Areas.
These areas must be:
- away from swimming pools and other bodies of water to prevent drownings
- generally level to prevent tipovers
- away from steps, steep inclines, cars, roads and alleys.
• Riding Rules
Make sure children know and follow these rules for safe driving and riding.
- Always sit on the seat.
- Always wear shoes.
- Only 2 (two) riders at a time.
- Never ride in cargo bed.
T6991a-0920
2
IMPORTANT INFORMATION
Read this manual carefully for important safety •
information and operating instructions before using
your vehicle. Keep this manual for future reference,
as it contains important information.
This vehicle is appropriate for use on generally •
level, rough terrain (including hard surfaces, wet
and dry grass, ruts, gravel, mulch and mud) and
by children 3 years of age and older. Do not exceed
the maximum total weight capacity of 130 lbs
(59 kg) in the passenger seating area and cargo
bed. Cargo bed weight limit: 25 lbs (11,3 kg).
Your new vehicle requires adult assembly. Please •
set aside at least 60 minutes for assembly.
This product contains a magnet. Do not use •
around items that are sensitive to or affected by
magnetic fi elds.
Use this vehicle • ONLY outdoors. Most interior
fl ooring can be damaged by riding this vehicle
indoors. Fisher-Price® will not be responsible for
damage to the fl oor if the vehicle is used indoors.
You must charge your battery for 18-30 hours •
before you use your vehicle for the fi rst time. We
recommend charging your battery before beginning
assembly. Please see the Battery Charging section for
detailed instructions.
The battery charger is not a toy. •
Do not short circuit the battery.•
Adults Note: • Regularly examine the charger for
damage to the cord, plug, housing or other parts
that may result in the risk of fi re, electric shock
or injury. In the event of any damage, do not
use the charger until the damage has been
properly repaired.
Your Power Wheels• ® 12 volt battery is equipped with
a built-in thermal fuse. The thermal fuse is a selfresetting safety device which automatically “trips” and
shuts down operation of the vehicle if the vehicle is
overloaded or the driving conditions too severe.
Once a fuse has “tripped”, remove your foot from
the pedal and wait approximately 25 seconds before
operating the vehicle again. To avoid repeated automatic
shut-downs, avoid severe driving conditions.
If a thermal fuse in a battery continually trips under •
normal driving conditions, please contact your local
Power Wheels® Authorized Service Center.
To prevent damaging the motors and gears, teach your •
child to stop the vehicle before switching direction.
If you have any questions about your Power Wheels• ®
vehicle, please call our toll-free service lines at
1-800-348-0751. Trained customer service
representatives are available to take your call in English
or French. Habla Español? Si usted tiene alguna pregunta
ó necesita asistencia llame gratis 1-800-348-0755 para
los Estados Unidos. Tenemos representantes que hablan
español para atender su llamada.
For your convenience, Power Wheels• ® maintains an
independently owned and operated Authorized Service
Center Network with more than 300 authorized service
centers nationwide. Our authorized service centers
will repair or replace parts under warranty at no extra
charge, and can perform non-warranty repairs for
a minimal charge. To fi nd the authorized service center
nearest you, please visit us online at
www.powerwheels.com or call 1-800-348-0751.
Please visit us online at • www.powerwheels.com to
register your vehicle.
3
T6991a-0920
PARTS
• If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than
return this product to the store.
• Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that
no parts are discarded.
• Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper
towel to remove any excess lubricant.
Front Grille
Vehicle
Hood
Seat
Grille Support
T6991a-0920
Cargo Bed
Long Seat Belt
4
2 Short Seat Belts
PARTS
Steering Wheel
Steering Column
Steering Wheel Cover
Part Not Shown: Label Sheet
2 Rear Wheels
12 Volt Charger
2 Hubcaps
12 Volt Battery
Steering Column Cap
3
#8 x
/4" Screw - 19
0,25" x 2,85" Pin - 1
Wire Clip - 2
Fasteners Shown Actual Size
For your convenience, we included extra fasteners!
Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.
5
T6991a-0920
PARTS PICTURE
T6991a-0920
Note: Some parts shown are assembled to both sides of the vehicle. Fasteners not shown.
6
BATTERY CHARGING
ELECTRICAL HAZARD
WARNING
• Battery can fall out and injure a child
if vehicle tips over. Always use
battery retainer.
• PREVENT FIRE
- Never modify the electrical system.
Alterations could cause a re
resulting in serious injury and could
also ruin the electrical system.
- Use of the wrong type battery
or charger could cause a re or
explosion resulting in serious injury.
- Use of Power Wheels
®
components
in products other than Power Wheels®
vehicles could cause overheating, re
or explosion.
• The battery must be handled by adults
only. The battery is heavy and contains
sulfuric acid (electrolyte). Dropping the
battery could result in serious injury.
• Never allow children to charge the
battery. Battery charging must be done
by adults only. A child could be injured
by the elec-tricity involved in charging
the battery.
• Read the safety instructions on
the battery.
• Examine the battery, charger and
their connectors for excessive wear
or damage each time you charge the
battery. If damage or excessive wear
is detected, do not use the charger or
the battery until you have replaced the
worn or damaged part.
CAUTION
Use the charger in dry locations only.
• Make sure you charge the battery for at least 18 hours
using the enclosed Power Wheels® 12 volt charger
before operating your vehicle for the fi rst time. Charge
the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your
battery and will void your warranty.
• Use only a Power Wheels® 12 volt charger with “12V”
connector (input 120 VAC, 60Hz, with an output of
12 VDC) to charge your Power Wheels® 12 volt battery.
Battery must be upright
while charging.
Charger
Connector
• Plug the charger connector into the battery socket.
• Plug the charger into a standard wall outlet.
Notes:
- If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the
charger into a ceiling outlet.
• Once the battery is charged, disconnect the battery
connector from the charger connector. Unplug the
charger from the wall outlet. Refer to the Battery
Installation section for instructions on installing your
battery. If your battery is already installed in your
vehicle, simply re-connect the motor harness connector
to the battery.
• You do not need to remove the battery from your
vehicle to recharge it.
• Before charging the battery, examine the battery case
for cracks and other damage which may cause sulfuric
acid (electrolyte) to leak during the charging process. If
damage is detected, do not charge the battery or use it
in your vehicle. Battery acid is very corrosive and can
cause severe damage to surfaces it contacts.
• Do not place the battery on a surface (such as kitchen
counter tops) which could be damaged by the acid
contained inside the battery. Take precautions to protect
the surface on which you place your battery.
• Charge the battery in a well ventilated area.
7
T6991a-0920
ASSEMBLY
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by
electrical items. Care should be taken in
unpacking and assembly of the vehicle.
Children should not handle parts,
including the battery, or help in assembly
of the vehicle.
Screws
Front Grille
Slot
1
• Fit the front grille to the vehicle, as shown.
• Be sure the tabs on both ends of the grille fit into the
groove in each fender.
FRONT VIEW
Tab
2
• Insert four screws into the top of the front grille
and tighten.
Hint: You may need to push the ends of the front grille
to insert and tighten the outer screws and push the
center of the front grille to insert and tighten the
middle screws.
3
Front Grille
TOP VIEW
Front
Wheel
Well
SIDE VIEW
T6991a-0920
• Insert a screw through both front wheel wells and into
the front grille. Tighten the screws.
8
ASSEMBLY
11
2
1
4
• Place the labels exactly as shown in the illustration and
avoid repositioning a label once it has been applied.
12
DASH VIEW
18
Steering Wheel
Large Opening
0,25" x 2,85" Pin
6
• Align the hole in the steering wheel with the hole in the
steering column.
• Insert the 0,25" x 2,85" pin all the way through the
hole in the side of the steering wheel and into the
steering column, as shown.
Steering Wheel Cover
Steering
Column
Lower Bend Down
5
• Wipe the steering column with a paper towel to remove
any excess lubricant.
• Position the steering wheel so that the large openingis upright.
• Position the steering column with the lower bend down, as shown.
• Fit the steering wheel onto the steering column.
7
• “Snap” the steering wheel cover onto the steering wheel.
Hint: If the steering wheel cover does not "snap" onto
the steering wheel, you have not properly assembled
the steering column to the steering wheel. Remove the
pin and the steering column from the steering wheel
and refer back to Assembly steps 5 and 6.
9
T6991a-0920
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.