|
|
FGr4S |
Receiver |
|
|
Introduction |
The FGr4S uses AFHDS 3 (Third Generation Automatic Frequency |
|
|
||
|
|
FGr4S AFHDS 3 |
|
|
|
PPM |
HoppingDigitalSystem).Itusesainternalsingleantennawithtwo- |
|
|
PWM i-BUS |
way transmission capabilities and is designed to be compact and |
|
|
|
easytoinstall.ItcanoutputstandardPPM,PWMandi-BUS. |
Receiver overview
Receiver installation diagram:
Antenna LED |
BIND i-BUS |
CH 1-CH 4
Signal + -
CH 1- CH 4 i-BUS
BIND
CH 1 - CH 4: Connects the servos, power supply or other components.
i-BUS:forchannel expansion. BIND: For bindcable.
Receiver interface diagram:
Antenna
远离金属。
To ensure good signal strength, make sure the receiver antenna is as far away from any metal parts when installing the receiver.
擎继续工作而引发事故。
1
Attention:
Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so may lead to unintended operation or loss of control.
Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive electrical noise. Keep the receiver's antenna at least 1cm away from conductive materials such as carbon or metal.
Do not power on the receiver during the setup process to prevent loss of control.
Binding
1.BIND
2. 状态
4. 下
6. 重复以上步骤重新对码。
http://www.flysky-cn.com
Copyright ©2018 Flysky Technology co., ltd
1.InsertthebindcableintothereceiversBINDport;
2.Plugthepowercableintoanyotherport,andthethe receiver'sLEDwillstarttoflashindicatingthatithasentered bindmode.
3.Putthetransmitterintobindmode;(Seethetransmitter's instructionmanualformoreinformation)
4.Bindingissuccessfulwhenthereceiver'sLEDstartstoflash slowly.Removethepowerandbindcablesfromthereceiver. Ifthetransmitterisbidirectionaltherecieverstatusindicator willnotfashslowly.
5.Reconnectthepowercabletothereceiver.
6.Checktomakesurethatthetransmitterandreceiverare workingasexpected,ifthereareanyissuesorunexpected operationfollowthestepsabovetobindagain.
Loading...