Page 1
Fluke-700ILF
In-Line Filter
Instruction Sheet
®
Introduction
The Fluke 700ILF In-line Filter is specifically designed to
trap fine particles from atmospheric air, compressed air, and
instrument air. It is used with the Fluke 713, 717, or 718
Pressure Calibrators. It can also be used to absorb small
quantities of liquid oil and water in droplet form. The filter
has the following specifications:
• Inlet fitting: 1/8 in. brass female NPT
• Outlet fitting: 1/8 in. brass male NPT
• Length: 2.125 in.
• Flange diameter: 1.875 in.
• Housing diameter: 1.560 in.
• Max pressure: 100 psi
• Max temperature: 200 °F
• Max flow: 10 SCFM
• Burst pressure: 375 psi
• Filtration: 1 micron
Contents
• Model 700ILF In-line Filter
• Instruction Sheet
How to Contact Fluke
To contact Fluke, call one of the following numbers:
USA: 1-888-99-FLUKE (1-888-993-5853)
Canada: 1-800-36 FLUKE (1-800-363-5853)
Europe: +31 402-678-200
Japan: +81-3-3434-0181
Singapore: +65-6799-5655
Anywhere in the world: +1-425-356-5500
Visit us on the World Wide Web at: www.fluke.com
Installation and Replacement
This filter is designed with a directional flow. It must be
installed using the female fitting as filter inlet to ensure
proper filtration. Do not install using the male fitting as filter
inlet.
Unit should be replaced immediately if it is accidentally
saturated with bulk liquid contaminants, or when you detect
a noticeable drop in airflow.
To ensure a proper seal, apply multiple layers of compatible
Teflon tape to the male threads of both the filter and the
input male connector at the filter input.
Note
The Fluke-700ILF is not designed to lower the
effluent dew point of air or gas, or to remove
contaminants in vapor form, such as solvents,
water vapor, trace hydrocarbon vapors, or
chemical compounds
Inlet
Outlet to Fluke-718
700ilf.eps
Limited Warranty and Limitation of Liability
This Fluke product will be free from defects in material and
workmanship for one year from the date of purchase. This warranty
does not cover fuses, disposable batteries, or damage from
accident, neglect, misuse, alteration, contamination, or abnormal
conditions of operation or handling. Resellers are not authorized to
extend any other warranty on Fluke’s behalf. To obtain service
during the warranty period, contact your nearest Fluke authorized
service center to obtain return authorization information, then send
the product to that Service Center with a description of the problem.
THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER
WARRANTIES, SUCH AS FITNESS FOR A PARTICULAR
PURPOSE, ARE EXPRESSED OR IMPLIED. FLUKE IS NOT
LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES OR LOSSES, ARISING FROM
ANY CAUSE OR THEORY. Since some states or countries do not
allow the exclusion or limitation of an implied warranty or of
incidental or consequential damages, this limitation of liability may
not apply to you.
Fluke Corporation Fluke Europe B.V.
P.O. Box 9090 P.O. Box 1186
Everett, WA 98206-9090 5602 BD Eindhoven
U.S.A. The Netherlands
PN 1567797 March 2000 Rev.2, 2/12
©2000-2012 Fluke Corporation. All rights reserved. Printed in U.S.A.
1
Loading...