P art #340
Dual Electric Fan without Controls
Setting Pull or Push Configuration:
At the factory, the model 340 is assembled to pull air. To push air, remove the
clips that hold the fan blades onto the motor shaft and turn the fan blade over.
Reinstall the clips to the motor shafts. Important: See wiring diagram (next
page), correct wiring must correspond with push or pull configuration.
Installation Instructions
Through Core Mounting Instructions (SEE DIAGRAM “A”)
Step 1: Position the electric fan against the radia-
tor, and mark the holes for mounting. (Some
applications may have A/C condensers and/or
transmission coolers on the front of the radiator.
Additional adjustments or modifications may be
necessary for installation).
Step 2: Rotate fan blades to make sure they are
free of obstructions.
Step 3: With a small Phillips screwdrive r, pass
through the marked holes, carefully spreading
the fins to allow easy passage for the nylon
bolts. Pass the bolts through the shroud holes
then twist the bolts through the radiator.
Step 4: Slide the washer onto the nylon bolt and
push on the push nuts until snug.
Step 5: Trim off any excess length on the nylon
bolts with a pair of side cutter, leaving about ¼”
beyond the push nut.
Diagram A
Rev. 04-26-10 98340 Page 1 of 2
Wiring Instructions
If using accessories such as a thermostatic control or relay, follow the wiring instructions included with
the accessories. Refer to the diagrams below.
The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E . Fif e , W A 98424, Telephone No . 253-922-2700, w arrants to the original purchasing user , that all Fle x-a-lite products to be free of
defects in material and workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase ma y
be returned to the factory through the point of purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defectiv e material or workmanship and not by misuse, accidental or improper installation, Flex-a-lite will replace the fan free of charge , transportation prepaid. Flex-a-lite will not be liable for incidental,
progressive or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the abov e limitation or exclusion
may not apply to you. This warranty giv es y ou specific legal rights and you ma y have other rights, which vary from state to state. The Flex-a-lite w arranty is in compliance with
the Magnuson-Moss Warranty Act of 1975.
Rev. 04-26-10 98340 Page 2 of 2
Loading...