Wipe the toy with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take apart.
www.fisher-price.com
Page 2
Battery
Replacement
For best performance, we
recommend replacing the batteries
that came with this toy with two,
new “AA” (LR6) alkaline batteries.
• Locate the battery compartment on
the bottom of the toy. Loosen the
screw in the door and remove it.
• Remove the exhausted batteries and
dispose of them properly.
• Insert two, new “AA” (LR6)
alkaline batteries.
• Replace the battery compartment door
and tighten the screw.
• If this product begins to operate
erratically, you may need to reset
the electronics. Remove the
batteries and reinstall.
• When sounds from this toy become
faint or stop, it’s time for an adult to
change the batteries.
• Protect the environment by
not disposing of this product
with household waste
(2002/96/EC). Check your
local authority for recycling
advice and facilities.
Battery Safety
Information
In exceptional circumstances, batteries
may leak fluids that can cause
a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
•
Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Page 3
Consumer Information
FCC Statement (United States only)
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void
the user’s authority to operate the
equipment. This device complies with
Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
ICES-003
• This Class B digital apparatus complies
with Canadian ICES-003.
• Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
NMB-003
• Cet appareil numérique de la classe B
est conforme à la norme NMB-003
du Canada.
• L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes:
(1) il ne doit pas produire de brouillage
et (2) l’utilisateur du dispositif doit être
prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le
fonctionnement du dispositif.