Page 1
W2005
W2005
www.fi sher-price.com
Page 2
Consumer
Soother Battery
Information
WARNING
Prevent Entanglement Injury
• This product may not attach
to all crib designs. Do not
add additional strings or
straps to attach to a crib
or playpen.
• Use ONLY attached to a crib
or playpen.
Please keep this instruction sheet •
for future reference, as it contains
important information.
This product includes four “AA” batteries •
in a disposable box. Batteries included
are for demonstration purposes only.
Before fi rst time use, remove the “AA”
batteries in the disposable box and throw
them away.
Requires four “C” (LR14) • alkaline batteries
and two “AAA” (LR03) alkaline batteries
for operation (batteries not included).
Adult assembly is required for battery •
installation and crib attachment.
Tool required for battery installation: •
Phillips screwdriver (not included).
This product contains magnets. Do not •
use around items that are sensitive to or
affected by magnetic fi elds.
Replacement
Before First Time Use: The soother includes
four “AA” batteries in a disposable box for
demonstration purposes only. Remove the
disposable box with “AA” batteries and
install four “C” (LR14) alkaline batteries.
1,5V x 4
"C" (LR14)
Locate the battery compartment on the •
back of the soother.
Loosen the screws in the battery compart-•
ment door and remove the door.
2
Page 3
Soother Battery
Remote Battery
Replacement
Open the tabs on the disposable box and •
lift to remove it.
Throw away the disposable box and the •
included “AA” batteries.
Insert four, new “C” (LR14) • alkaline
batteries in the battery compartment.
Hint: We recommend alkaline batteries
for longer battery life.
Replace the battery compartment door •
and tighten the screws.
If the soother begins to operate •
erratically, you may need to reset the
electronics. Slide the power/volume
switch off and then back on.
Hint: Under normal use conditions,
the batteries in the soother will require
replacement more often than the batteries
in the remote. When sounds and lights from
this soother become faint or stop, it’s time
for an adult to change the batteries.
Installation
1,5V x 2
“AAA” (LR03)
Locate the battery compartment on the •
back of the remote.
Loosen the screw in the battery compart-•
ment door and remove the door.
Insert two, new “AAA” (LR03) •
alkaline batteries.
Hint: We recommend alkaline batteries
for longer battery life.
Replace the battery compartment door •
and tighten the screw.
If the remote begins to operate erratically, •
you may need to reset the electronics.
Remove the batteries and reinstall them.
3
Page 4
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. •
Increase the separation between the equipment and receiver. •
Consult the dealer or an experienced radio/TV technician for help.•
Note: Changes or modifications not expressly approved by the manufacturer responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. W2005pr-0920
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
4
Page 5
Crib Attachment
7" (18 cm)
Strap Slot
ggg
g
b
b
Attachment Strap
IMPORTANT! Always attach all provided
fasteners (strings, straps, clamps, etc.)
tightly to a crib or playpen according to
the instructions. Do not add additional
strings or straps to attach to a crib.
Check frequently.
Attachment Strap
Crib Rail
Strap Slot
Attached to Peg
1
1
Crib Spindle
2
1
Tie the soother strings to a crib spindle.•
NOTE: It is better to tie the strings in a knot
than a bow, since a bow may be easily untied.
Position the soother inside the crib.•
Wrap the attachment strap around the •
top of the crib rail.
Slide the end of the attachment strap •
under the tab on the back of the soother.
Fasten the attachment strap slot to the •
peg on the back of the soother.
NOTE: This soother should be snug against
the crib rail and spindles. Use the strap slot
that provides the tightest fi t.
7" (18 cm)
3
1
Make sure the distance between the •
bottom of the soother and the crib
mattress is at least 7 inches (18 cm).
If the distance is less than 7 inches •
(18 cm), readjust the attachment strap to
lift the soother; or lower the crib mattress.
5
Page 6
Remote Use
Remote
Receiver Arrow
Position the soother so that the receiver •
arrow points towards the area that the
remote will be used. Make sure there is
a clear path between the remote and
the soother.
Point the end of the remote toward the •
soother receiver and press the button.
NOTES:
In the unlikely event that use of the •
remote interferes with normal use of
other remote controlled equipment, such
as televisions and stereos, or use of other
electronic or battery powered appliances
interfere with operation of the soother, do
not use both at the same time.
You may notice a loss of range between the •
remote and the soother when using in bright
light. For best performance, avoid using the
remote in areas of bright light. Move the
soother, or reduce the amount of light to
improve performance.
6
Page 7
Stories in Song, Light Show & Night Light
Power/Volume
Switch
Mode Switch
Night Light
Button
Turn the page to
Projection
Light Show
Night Light
Button
Turn the page to
change the song.
Soft Glowing Night Light
Start/Stop Button
Projection
Light Show
Power/Volume
Switch
Slide the power/volume switch on the •
soother to ON with low volume or
ON with high volume .
Slide the mode switch to: • Music
or Music & Projection.
Music - plays approximately
20 minutes of music.
Music & Projection - plays
approximately 12 minutes of music
and projects a charming light show
on the ceiling.
Mode Switch
Press the start/stop button on the soother •
or the remote button to turn music/
projection ON. Press the button again to
stop music/projection.
Turn the pages in the book to change •
the song.
Press the • night light button on the
soother for soft glowing light.
Hint: The night light turns OFF after
approximately two minutes.
When you are fi nished using this product, •
slide the power/volume switch OFF .
7
Page 8
Consumer Information
Care
Wipe this toy with a clean cloth •
dampened with a mild soap and water
solution. Do not immerse.
This toy has no consumer serviceable •
parts. Do not take this toy apart.
Protect the environment by not •
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
ICES-003
This Class B digital apparatus complies •
with Canadian ICES-003.
Operation is subject to the following two •
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B est •
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée •
seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
Battery Safety Information
In exceptional circumstances, batteries
may leak fl uids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
Do not mix old and new batteries or •
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
Insert batteries as indicated inside the •
battery compartment.
Remove batteries during long periods •
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fi re. The batteries inside
may explode or leak.
Never short-circuit the battery terminals.•
Use only batteries of the same or •
equivalent type, as recommended.
Do not charge non-rechargeable •
batteries.
Remove rechargeable batteries from the •
product before charging.
If removable, rechargeable batteries are •
used, they are only to be charged under
adult supervision.
8
Loading...