Fisher-Price W1710 User Manual
W1710
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” (LR6) alkaline batteries (not included) for operation.
Adult assembly is required. Required tool: Phillips screwdriver (not included).
Wipe with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take apart.
www.fisher-price.com
Assembled Parts
CAUTION
This product contains small parts in an unassembled state.
Adult assembly is required.
Base
Canopy Swing
Flag
Hut Roof
Part not shown: Label Sheet
Gate
Handle
Teeter-totter
Peek-a-boo Door
Upper Ramp
Lower Ramp
WallTree
5
#6 x
" (1,6 cm) Screw – 3
8
Platform
Large Tree Canopy
Shown Actual Size
Tighten all screws with a Phillips
screwdriver. Do not over-tighten.
1
Assembly
Tr
Back View
Wall
Screw
Tree
Back View
1
• Fit the tree onto the wall.
• Lay the assembly face down on a fl at surface and insert a screw into the wall and tighten.
Teeter-totter
Post
2
• Turn the assembly over.
• Fit the post on the teeter-totter into the hole in the wall assembly.
Hint: You may need to turn the teeter-totter to fit it in place.
• Push to “snap” in place.
2
Assembly
3
• Turn the assembly upright.
• Fit the tabs on to the bottom of the wall assembly into the slots in the base.
Hint: If the tabs on the wall assembly do not seem to fit, turn it around and try again!
• Push near each tab to “snap” in place.
Peek-a-boo Door
4
• At an angle, fi t the peg on one side of the peek-a-boo door into the socket in the wall.
• Then, push to “snap” the other peg in place.
Hut Roof
5
• Fit the tabs on the hut roof into the slots in the tree. Push to “snap” in place.
3
Loading...