Page 1
www.fisher-price.com
V9961
V9961
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly required.
Requires one "AAA" battery (included).
Tool required for battery replacement: Phillips screwdriver (not included).
Page 2
Assembled Parts
CAUTION
This product includes small
parts in an unassembled state.
Adult assembly is required.
Roof
Tower Base
2 Upper Ramps 2 Lower Ramps
#4 x ½" (1,3 cm) Screw - 4
SHOWN ACTUAL SIZE
2
Page 3
Battery
Battery Safety
Replacement
1,5V
"AAA" (LR03)
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the toy. Dispose of batteries safely.
Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy
before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Loosen the screws in the bottom of the •
vehicle with a Phillips screwdriver. Lift the
top of the vehicle off of the chassis to
access the battery compartment.
Remove the exhausted battery and •
throw it away.
Insert a new "AAA" (LR03) • alkaline battery.
Hint: We recommend using an alkaline
battery for longer battery life.
Replace the bottom of the vehicle and •
tighten the screws. Do not over-tighten.
If this toy begins to operate erratically, •
you may need to reset the electronics.
Remove the battery and replace itt in
the toy.
When sounds from this toy become •
faint or stop, it’s time for an adult to
change the battery.
3
Page 4
Assembly
Tower
Base
1
Fit the tabs on the tower into the slots in the •
base. Push to "snap" the tower in place.
Lower Ramp
Upper Ramp
2
Fit the tabs on the upper ramp into the slots •
in the lower ramp.
Insert two screws into the upper ramp. •
Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Repeat this procedure to assemble the other •
upper and lower ramps.
3
Fit a track onto each side of the tower. •
Roof
4
Fit the tabs on the roof into the slots on the •
tower. Push to "snap" the roof in place.
5
Page 5
Help Holley Escape!
1
Push down on the vehicle to hear fun sounds!•
2
Press the button on the side of the tower to •
lock the upper fl oor.
Place the vehicle on the upper fl oor in the •
direction shown.
3
Drive another vehicle (sold separately) in the •
opposite direction through the tower. Watch
the fl oor drop the vehicle on the track for
a quick escape!
6
Page 6
ASSISTANCE
Consumer Information
FCC Statement (United States Only)
NSUMER
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Care
Wipe the toy with a clean, damp cloth. Do not •
immerse the vehicle.
This toy has no consumer serviceable parts. •
Do not take this toy apart.
ICES-003
This Class B digital apparatus complies with •
Canadian ICES-003.
Operation is subject to the following two •
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B est •
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée •
seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage
et (2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment. This device complies
with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
©Disney/Pixar
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. , unless otherwise indicated.
PRINTED IN CHINA V9961pr-0920
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
4
Loading...