Fisher-Price V1578 Instruction Sheet

Track Layout

B

C

E

BATTERY INSTALLATION

Unscrew and lift cover away from Thomas.

E

E

E

A

A A

E

A

B

D

G

B

B

F

B

A

A

B

B

Install batteries as indicated inside the battery compartment.
For longer life use only alkaline batteries.
If this toy begins to operate erratically, you may need to reset the electronics.
Remove the batteries from the toy and replace it.
Requires 1 “AA” (LR6) batteries.

BATTERY SAFETY INFORMATION

In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin
your toy (product). To avoid battery leakage:

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the product before being charged

(if designed to be removable).

• Rechargeable batteries are only to be charged under adult supervision

(if designed to be removable).

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.

• Do not mix old and new batteries.

• Only batteries of the same or equivalent type as recommended are to be used.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the product.

• The supply terminals are not to be short-circuited.

• Dispose of battery(ies) safely.

• Do not dispose of this product in a fire. The batteries inside may explode or leak.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. Consult the dealer or an experienced radio/TV technician for help.

NOTE: Changes or modifications not expressively approved by the manufacturer responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.

• THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

• CET APPAREIL NUMERIQUE DE LA CLASSE B EST CONFORME A LA NORME NMB-003 DU
CANADA.

• Operation is subject to the following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.

• L’utilisation de ce produit est sujette aux conditions suivantes : (1) il ne doit pas produire de

brouillage et
(2) il doit pouvoir tolérer tout brouillage reçu, même si ce brouillage est susceptible de compromettre
son fonctionnement.

Phillips screwdriver (not included)

On

1,5V x 1

“AA” (LR6)

Required tool:

Off

TM

INSTRUCTIONS

Please keep these instructions for future reference as they contain important information.

3-Way Tunnel Installation

Checklist

A

X 6

Straight Curve

E

X 5

B

X 7

F

X 1

G

X 1

Turntable x 1
Outer Walls x 2
Roofs x 4
Doors x 4
Support
Columns x 2Buffer Stop

NOTE: Adults should remove & discard rubber bands holding tracks together.

C

X 1

Turn Out (Left)

Tidmouth

Sheds

D

X 1

Stop/Go Track

Thomas3-Way Tunnel

Protect the environment by not disposing of this product with household
waste (2002/96/EC). Check your local authority for recycling advice and
facilities (Europe only).

Based on the Railway Series by The Reverend W Awdry.
© 2010 Gullane (Thomas) Limited.
Thomas the Tank Engine & Friends and
Thomas & Friends are trademarks of Gullane (Thomas) Limited.
© HIT Entertainment Limited.
HIT and the HIT logo are trademarks of HIT Entertainment Limited.
Fisher-Price, Inc., a subsidiary of Mattel, Inc.,
East Aurora, NY 14052 U.S.A.

PRINTED IN CHINA.

Manufactured for Fisher-Price.©2010 Mattel, Inc.
All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc.,
unless otherwise indicated.
Mattel East Asia Ltd., Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui,
HK, China.

CAUTION:

To prevent entanglement,
keep hair away from wheels.

V1578

ID. V1578-0920

1 2

ADULT ASSEMBLY REQUIRED.

No tools required for assembly.

Tidmouth Sheds Assembly

1

Snap shed doors into turntable.Snap shed doors into turntable.

Assemble roof.

2

Sections snap together easily.

Position roof on top of shed doors.

3

4

5

Connect shed's outer walls to the roof and doors.

1

Front View

2

Pegs on bottom of
outer walls should
snap into turntable.

How To Play

1

Push the lever FORWARD
to stop the engine on the
turntable.
The engine wheels will
drive the gears, causing
the turntable to rotate.

Push the lever BACKWARD

2

to stop the turntable at
the desired track section
or shed door.

Use firm pressure to
snap roof and doors together.

6

7

Back View

Support columns

Push the lever to the side

3

to release the engine.
Keep the lever in the
SIDE position to allow the
engine to pass over the
turntable without stopping.

Item No : V1578-0920
Version : EL
Size : 24.8" x 11.69"
Paper : Woodfree paper 80 gsm
Color : Black
Date : Nov. 11, 2010 (WC)

Side 1

Side 2

Instruction page sequence:

P.6P.5

P.2 P.4

P.3

COVER