Page 1
M6567
www.fisher-price.com
Page 2
Battery Installation Battery Safety
Information
1.5V x 3
"AA" (LR6)
In exceptional circumstances, batteries
may leak fluids that can cause a
• Locate the battery compartment door
on the bottom of the car.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert three, new "AA" (LR6)
alkaline
batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.
• When sounds or motions become
faint or stop, it’s time for an adult to
change the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
chemical burn injury or ruin your toy.
To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of
batteries safely. Do not dispose of the
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the toy before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Page 3
Shake It, Then Race It!
1
2
3
4
5
Note: The vehicle shown in the photographs may be different than the vehicle included with your toy.
1
• Slide the power switch on the bottom
of the car on .
• Place the car in the back of the trailer.
2
• “Drive” your car to the race.
4
• Shake the car to start the "engine" and
the sound effects.
Hint: For maximum distance, shake
the car 7 or 8 times. Shaking more
than this does not increase the
distance it will travel.
5
• Place the car on the arrow on the
back of the trailer.
• Press the pedal to go!
• When you're finished, slide the power
switch on the car off .
3
• Lift and lower the trailer and it
becomes a starting gate.
Page 4
Consumer Information
FCC Statement
• Please keep this instruction sheet
for future reference, as it contains
important information.
• Requires three "AA" (LR6) alkaline
batteries (not included) for car
operation. Adult assembly is
required (for battery installation).
• Tool required for battery installation:
Phillips screwdriver (not included).
• This product is not recommended for
use on loose dirt or wet surfaces.
• Wipe this toy with a clean cloth
dampened with a mild soap and
water solution. Do not immerse
this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
United States Only
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer responsible for compliance
could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: this device may not cause
harmful interference and this device
must accept any interference received,
including interference that may cause
undesired operation.
Disney/Pixar elements ©Disney/Pixar, not including underlying vehicles owned by third parties:
PRINTED IN CHINA M6567pr-0920
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Hudson Hornet™, Chevrolet Impala™, Mercury™ and Petty®.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©Disney/Pixar
Loading...