Fisher-Price M5726 User Manual
www.fi sher-price.com
with Assembly Instructions
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool needed for assembly: Phillips screwdriver (not included).
Water or sand is needed to fi ll the bases (not included).
IMPORTANT!
Backboard height should be adjusted only by an adult.
M5726
1. Basketball
2. Football
M5726
3. Soccer
4. Baseball
5. Hockey
Owner's Manual
with Assembly Instructions
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool needed for assembly: Phillips screwdriver (not included).
Water or sand is needed to fi ll the bases (not included).
IMPORTANT!
Backboard height should be adjusted only by an adult.
www.fi sher-price.com
2
ASSEMBLED PARTS
ASSEMBLED PARTS
Net Tube
Rim
Backboard
2 Upper Posts
Base Tube
2 Side Tubes
2 Post Covers 2 Base Covers
Net
2 Bases
2 Lower Posts
2
2 Plugs
Label Sheet
#8 x 3/4” Screw – 36
#10 x 1 1/2” Screw – 2
BOTH SHOWN ACTUAL SIZE
Note: Tighten all screws with a Phillips
screwdriver. Do not over-tighten the screws.
3
CAUTION
ASSEMBLY
ASSEMBLY
1
This product contains small parts
in its unassembled state.
Adult assembly is required.
Posts
2
1
2
Printed Side Up
Sleeve
Base Tube
• Place the net, printed side up, on a flat surface.
• Slide the base tube through the sleeve on the bottom of the net.
Bases
• Place the bases on a flat surface.
• Note the numbers on the bases and on the posts.
• Insert and “snap” the post labeled 1 into the base labeled 1.
• Insert and “snap” the post labeled 2 into the base labeled 2.
3
2
Base Tube
IMPORTANT! Position the base assemblies as shown. Note the
labels 2 and 1.
• Place the base assemblies onto the ends of the base tube.
1
3
4
ASSEMBLY
4
Side Tube
Sleeve
Sleeve
Side Tube
ASSEMBLY
6
Post
Grooves
• Slide a side tube, straight end first, through the sleeve on each
side of the net.
5
Side Tubes
• Lift the side tubes up and set the ends in the notch in each
base assembly.
Hint: The top of the net will flop forward.
• Fit the upper end of the side tubes into the groove in each post.
7
2
Base Covers
• Note the numbers on the base covers.
• Fit the base cover labeled 1 onto the base assembly labeled 1.
Hint: Make sure the net is not under the base cover.
• Insert four #8 x 3/4” screws into the base cover and tighten.
• Repeat this procedure to attach the other base cover labeled
2
to the base assembly labeled 2.
1
4
Loading...