Page 1
Please keep this instruction sheet for future reference,
as it contains important information.
Requires four “D” batteries
(included) for operation.
Adult assembly is required for battery replacement.
Tool required for battery replacement:
Phillips screwdriver (not included).
www.fisher-price.com
Page 2
Consumer Information
WARNING
Prevent falls
and entanglement:
This product will not attach to
all crib designs. Do not add
additional strings or straps to
attach to a crib or playpen.
Before Use
CAUTION
Please keep small parts
such as plastic tabs out
of children’s reach.
Throw the plastic tab away.
Note: A plastic tab was attached to the
toy for in-store demonstration purposes.
While the tab may have already been
removed, check the back of the toy to be
sure. If the plastic tab is still attached, pull
and remove the tab from the toy. Throw
the plastic tab away.
Crib Attachment
IMPORTANT! Always attach all provided
fasteners (strings, straps, clamps, etc.)
tightly to a crib or playpen according to
the instructions. Do not add additional
strings or straps to attach to a crib.
Check frequently.
Attachment
Slot
Button
IMPORTANT! If you are attaching this toy
to a crib side rail that can be lowered
and raised, make sure the crib side rail
is in the raised (locked) position whenever a child is in the crib.
• Position the toy inside the crib.
• Wrap one of the toy’s attachment
straps around the crib rail.
• Fasten the attachment strap slot to the
button on the back of the toy.
• Repeat this procedure to secure the
other attachment strap.
Note: This toy should be snug against
the crib rail and spindles. Use the strap
slot that provides the tightest fit.
Strap
Crib Rail
2
Page 3
Crib Attachment
• Tie the toy’s strings to a crib spindle.
Note: It is better to tie the strings in a
knot than a bow, since a bow may be
easily untied.
Bottom
of Product
• Make sure the distance between the
bottom of the product and the crib
mattress is at least 7 inches.
• If the distance is less than 7 inches:
readjust the attachment straps to lift
the product; or lower the crib mattress.
Mattress
3
Page 4
Soothing Sights and Sounds
Mode Switch
Start/Stop Button
Volume Switch
Light Button
Mode Switch Start/Stop Button
Listen to up to 22 minutes of
music only.
Enjoy up to 15 minutes of music,
soft lights and motion.
Watch an enchanting ceiling light
show along with soothing music,
calming lights and gentle motion
(up to 11 minutes).
Slide the switch to the off position
when the toy is not in use.
Press to stop or start music and lights.
Volume Switch
Slide to either low, medium or
high volume.
Light Control Button
Press to select a soothing night
light; press again for twinkling lights
only in and modes.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. M3623pr-0920
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Page 5
Battery Replacement
For best results, we recommend
replacing the batteries that came
with this toy with four, new “D” (LR20)
alkaline batteries.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert four “D” (LR20) alkaline
batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• If sounds, lights or motions from this
toy become faint or stop, it’s time for
an adult to change the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Battery Safety
Information
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose
of batteries safely. Do not dispose of
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
•
Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
1.5V x 4
“D” (LR20)
5
Page 6
Consumer Information
Care
• To clean, wipe the surface of this toy with
a damp cloth. Do not immerse this toy.
• Do not drop this toy on a hard surface.
• This toy has no consumer serviceable
parts. Please do not take this toy apart.
FCC Statement (United States Only)
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
6
Loading...