Page 1
CHR11
CHR11
1
2
3
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three AA (LR6) alkaline batteries (not included) for operation.
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
Use as a mobile from birth until 5 months.
A mobile is intended for visual stimulation and not to be grasped by a child.
Wipe this toy with a clean, damp cloth. Do not immerse this toy.
fisher-price.com
1
Page 2
Assembled Parts
WARNING
Prevent Entanglement Injury
Crib Mobile Use
• Keep out of baby’s reach.
• Remove mobile from crib or playpen when baby begins to push up on
hands and knees.
• This product may not attach to all crib designs. Do not add additional
strings or straps to attach to a crib or playpen.
Stroller Toy Use
• Do not attach link directly to crib or playpen.
Mobile Clip
Mobile Base
Mobile Arm
Bird
Link Toy
2
Page 3
Crib Mobile Assembly
Mobile Arm
Mobile Base
1
• Fit the mobile arm into the socket in the top of the base. Push to “snap” in place.
Mobile Clip
2
• Fit the mobile clip onto the free end of the mobile arm.
• Push to “snap” in place.
3
Page 4
Crib Mobile Assembly
Bird
Ring
3
• Fit the bird onto the mobile clip.
Hint: You may need to turn the ring on the bottom of the bird to fit through the slot in the
mobile clip.
Link Toy
4
• Fit the open end of the link toy onto the ring on the bird.
4
Page 5
Bird Battery Installation
1,5V x 3
AA (LR6)
For longer life, use
alkaline batteries.
• Loosen the screw in the battery compartment door and remove the door.
• Insert three AA (LR6) alkaline batteries.
• Replace the battery compartment door and tighten the screw. Do not over-tighten.
• If this toy begins to operate erratically, you may need to reset the electronics. Slide the
power/volume switch off and back on.
• When sounds/motion become faint or stop, it's time for an adult to change the batteries.
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the
product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
5
Page 6
Consumer Information
CONSU
ASSISTANC
1-800-432-5437 (US & Canada)
MER
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) l’utilisateur
du dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le
fonctionnement du dispositif.
E
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.However, there is no
guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not
expressively approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
PRINTED IN CHINA CHR11_1100209893_DOM
©2014 Mattel. All Rights Reserved.
6
Page 7
Crib Mobile Attachment
Attachment Strap
Peg
IMPORTANT! Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to
a crib or playpen according to the instructions. Do not add additional strings or straps to
attach to a crib. Check frequently.
Crib Rail
B
A
D
Peg
Attachment Strap
C
1
• Position the toy inside the crib. Make sure the attachment strap is on the outside of the crib A.
• Slide the end of the attachment strap down through the slot on the back of the toy B.
• Pull the end of the attachment strap up and fasten to the peg on the back of the toy C.
Note: This toy should be snug against the crib rail and spindles. Use the strap slot that provides
the tightest fit.
• If you have excess strap, slide the free end of the attachment strap up through the opening near
the top of the attachment strap D.
7
Page 8
Crib Mobile Attachment
Mattress
Bottom of Soother
At Least 7 Inches (18 cm)
2
• Tie the toy’s strings to a crib spindle.
Note: It is better to tie the strings in a knot than a bow, since a bow may be easily untied.
Bottom of Soother
At Least 7 Inches (18 cm)
3
• Make sure the distance between the bottom of the mobile base and the crib mattress is at least
7 inches (18 cm).
• If the distance is less than 7 inches (18 cm): readjust the attachment straps to lift the toy; or
lower the crib mattress.
Mattress
8
Page 9
Crib Mobile Use
Press
Press
• Slide the power/volume switch to ON with low volume , ON with high volume or OFF .
• Press the button on the front of the bird to start the mobile and sounds.
Hints:
• The sounds will play for approximately 20 minutes.
• The mobile will turn off after approximately 12 minutes.
• Press the button on the bird to restart sounds/mobile.
9
Page 10
Stroller Fun
Press
• Pull the link toy off the ring on the bird.
• Fit the open end of the link toy onto a stroller canopy.
Take Along Music
C
Press
B
A
• Remove the mobile from the crib.
• Pull the link toy off the ring on the bird.
• Turn the ring on the bottom of the bird A. Then, press the front of the mobile clip B and lift to
remove the bird C.
Hint: When used in take along mode, the bird will play short tunes and sound effects.
10
Loading...