Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) l’utilisateur
du dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le
fonctionnement du dispositif.
E
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.However, there is no
guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
NOTE: Changes or modifications not
expressively approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
one way. If it does not seem to fit, try the
other base.
Mat
2 Hanging Toys
3
Page 4
Battery
Installation
Battery Safety
Information
1,5V x 3
AAA (LR03)
• For longer life, use alkaline batteries.
• Locate the battery compartment door on the
bottom of the arch.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Insert three, new AAA (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• If this product begins to operate erratically,
you may need to reset the electronics. Slide
the power/volume switch off and then
back on.
• When sounds/lights become faint or stop,
it’s time for an adult to change the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbonzinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
4
Page 5
Newborn Mode
Dancing lights and hanging toys entertain baby.
1
Straps
Mat
1
Fit each strap on the mat into each slot in the base feet. Make sure the tab on each strap forms
a "T" on the other side of the slot. Pull up on the mat to be sure it is secure.
2
Hang the toys from the straps on the arch.
2
Straps
5
Page 6
Sitter Mode
Pockets on the mat provide put & take fun for sitting babies.
3
2
1
Hint: If converting from newborn mode, remove each strap on the mat from each slot in the
base feet.
1
Fit the lower straps on the mat into the slots in the front base feet. Make sure the tab on each
strap forms a "T" on the other side of the slot.
2
Fold the top of the mat over.
3
Insert the plastic tabs on each side of the mat into the slots in the base.
6
Page 7
Toddler Mode
Stand up and roll the balls down the ramp for even more excitement!
3
2
4
1
Remove the plastic clips on the mat from the slots in the base.
2
Remove the lower straps on the mat from the slots in the front base feet. Store the mat for
future use.
3
Lower the door on each foot.
4
Remove the hanging toys from the arch and fit onto the pegs on each foot.
7
1
Page 8
Music, Sounds Effects & Lights!
Sounds Effects & Lights!
,
Power/Volume
Switch
• Slide the power/volume switch to ON with low volume , ON with high volume or
OFF .
• Slide the mode switch to:
Short Play - pull the owl, bat at the toys or roll a ball down the arch for sound
effects & lights.
Long Play - pull the owl, bat at the toys or roll a ball down the arch to play approximately
20 minutes of music and sounds.
8
Mode Switch
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.