Fisher-Price 73889 User Manual

Projector and Telescope

Instructions

Model Number: 73889

Please save these instructions for future reference.

Adult assembly is required.

Requires four “C” (LR14) alkaline batteries

for operation (not included).

Requires one KPR113 Krypton light bulb (included).

Adult assembly required for battery installation

and light bulb replacement.

Tool required for battery installation and light bulb replacement:

Phillips screwdriver (not included).

Battery Tips:

• Do not mix old and new batteries.

• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).

• Remove the batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Battery leakage and
corrosion can damage this toy. Dispose of battery(ies) safely.

• Never short circuit the battery terminals.

• Non-rechargeable batteries are not to be recharged.

• Only batteries of the same or equivalent type as recommended
in the “Battery Installation” instructions are to be used.

• If removable rechargeable batteries are used, they are only to be
charged under adult supervision.

• Rechargeable batteries are to be removed from the toy before
they are charged.

• If you use a battery charger, it should be examined regularly for
damage to the cord, plug, enclosure and other parts. Do not use
a damaged battery charger until it has been properly repaired.

Battery Installation

• Loosen the screw in the
battery compartment door
with a Phillips screwdriver.

• Lift the battery compartment
door to open. (The screw will
remain in the door.)

• Insert four “C” (LR14) alkaline
batteries as indicated inside the
battery compartment.

• Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.

Battery
Compartment

1.5V x4

“C” (LR14)

Shown Actual Size

2

Assembly

Hole

Threaded Bar

Plastic Screw

Tripod

• Place the projector/telescope upside-down on a flat surface.

• Position the tripod with the rib side facing down.

• Insert the tripod into the center slot on the projector/telescope.

• Align the holes in the projector/telescope with the hole
in the tripod.

• Push the threaded bar through the holes in the projector/telescope
and the tripod.

• Place the plastic screw on the end of the threaded bar and tighten.
Do not over-tighten.

3