Model Number 73540
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “C” (LR14) alkaline batteries (not included).
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
D
i
s
c
o
v
e
r
w
h
a
t
’
s
p
o
s
s
i
b
l
e
™
…
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Spinning Tunes
Activity Table
Spinning Tunes
Activity Table
Spinning Tunes
Activity Table
™
• Locate the batter y compar tment
door on the table top.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Inser t three “C” (LR14) alkaline bat-
teries, as indicated inside the battery compar tment.
Hint: We recommend using alkaline
batteries for longer life.
• Replace the batter y compar tment
door and tighten the screws with a
Phillips screwdriver.
Do not over-tighten.
• When sounds or movements on this
toy become faint or stop, it’s time for
an adult to change the batteries!
Battery Installation
Battery
Compartment
Door
2
1.5V x 3
“C” (LR14)
Shown Actual Size
3
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use. Always remove
exhausted batteries from the toy.Battery leakage and corrosion can damage this toy.Dispose of batteries safely.
• Do not dispose of batteries in a fire. The batteries may explode or leak.
• Never short circuit the battery ter minals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended in the
“Battery Installation” instr uctions are to be used.
• If removable rechargeable batteries are used, they are only to be charged
under adult supervision.
• Rechargeable batteries are to be removed from the toy before they
are charged.
• If you use a battery charger, it should be examined regularly for damage to
the cord, plug, enclosure and other parts. Do not use a damaged battery
charger until it has been properly repaired.
Battery Tips
4
• Lift the table top off the table base and remove the legs from the tray area.
• Position the table base upside-down on a flat surface.
• Position a leg upside down with the “X” and swirl patterns facing you.
• Fit the end of the leg into the cor ner of the table base, as shown.
• Press fir mly to fit the raised circle on the end of the leg into the large hole
in the table base.
Table
Base
Raised
Circle
“X”
Swirl
Leg
Large Hole
1
Assembly
5
• Position another leg upside down with the star and heart facing you.
• Fit the end of the leg into the cor ner of the table base, as shown.
• Press fir mly to fit the raised circle on the end of the leg into the large hole in
the table base.
• Repeat this step one and two to assemble the other legs to the table base.
Raised
Circle
Heart
Leg
Left
Corner
Large Hole
Table Base
Star
2
Assembly
• Stand the base assembly upright.
• Fit the table top on the base assembly.
Table Top
Base
Assembly
3
Assembly
6
• Locate the power/volume switch on the table top.
• The switch has three positions: off , on with low volume and on with
high volume .
Power/Volume Switch
• Slide the switch to off position when the toy is not in use.
Music and Motion
The table top is two sided with spinning disks on one side or
building block fun on the other!
• Stack the blocks on any of the pegs on the table top.
• Press the “action” button for spinning disks and fun music.
Note: If this toy does not respond when the action button is pressed,
it’s time to replace the batteries!
7
Action Button
• Wipe this toy with a clean cloth dampened with a mild soap and water
solution. Do not immerse this toy.
• This toy has no consumer serviceable par ts. Do not take this toy apart.
Care
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
© 2002 Mattel, Inc. All Rights Reserved.® and ™ designate U.S.trademarks of Mattel, Inc.
Printed in Mexico 73540pr-0920
Questions? We'd like to hear from you!
Call Fisher-Price®Consumer Relations, toll-free at 1-800-432-KIDS,
8 AM - 6 PM EST Monday through Friday. Hear ing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470.Or, wr ite to:
Fisher-Price®Consumer Relations, 636 Girard Avenue, East Aurora,
New York 14052.
For other countries, outside the United States:
Canada: call 1-800-567-7724, or write to:Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2. Great Britain: telephone 01628 500302.
Australia: Mattel Australia Pty.Ltd., 658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia.Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Consumer Information
Note:This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.These
limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause har mful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:Changes or modifications not expressly approved by the manu-
facturer responsible for compliance could void the user's authority to operate the equipment.
FCC Note (United States Only)
Loading...