D
i
s
c
o
v
e
r
w
h
a
t
’
s
p
o
s
s
i
b
l
e
™
…
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Product Number: 73437
Musical
Fingerpaint
Musical
Fingerpaint
Musical
Fingerpaint
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required for battery replacement.
Tool required for battery replacement: Phillips screwdriver (not included).
•Locate the battery compartment door on the back of the toy.
•Loosen the screws in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries,as indicated inside the battery
compartment.
Hint: We recommend using alkaline batteries for longer life.
•Replace the battery compartment door and tighten the screws with a
Phillips screwdriver. Do not over-tighten.
•When sounds from this toy become faint or stop,it’s time for an adult
to change the batteries!
For best performance, we recommend replacing the batteries that
came with this toy with three, new alkaline “AA” (LR6) batteries.
Battery Replacement
Battery
Compartment
Door
2
1.5V x 3
“A A” (LR6)
Shown Actual Size
•Do not mix old and new batteries.
•Do not mix different types of batteries: alkaline,standard
(carbon-zinc) or rechargeable (nickel-cadmium).
•Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the toy. Battery leakage
and corrosion can damage this toy. Dispose of batteries safely.
•Do not dispose of batteries in a fire.The batteries may
explode or leak.
•Never short circuit the battery terminals.
•Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended in
the “Battery Replacement” instructions are to be used.
•If removable rechargeable batteries are used,they are only to be
charged under adult supervision.
•Rechargeable batteries are to be removed from the toy before
they are charged.
•If you use a battery charger, it should be examined regularly for
damage to the cord, plug, enclosure and other parts. Do not use a
damaged battery charger until it has been properly repaired.
Battery Tips
3
•Locate the power/volume switch on the
back of the toy.
•The switch has three positions: off ;
on with low volume and on with high
volume .
Power/Volume Switch
Let’s Draw!
4
•Baby can create drawings with fingers or with one of the four drawing
tools included.
•The music stops and starts as baby draws, or press the music button to hear
an entire song.
Note:If the screen is broken or leaking, be sure to throw this toy away.
Drawing
Tools
Music
Button
•Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse this toy.
•This toy has no consumer serviceable parts. Do not take this
toy apart.
Erasing
Care
5
•To clear the screen,slide the eraser roller up and down.
All Finished!
• “Snap” the drawing tools into the storage areas.
•Slide the power/volume switch to the off position.
Hint:If your child is not actively playing with this toy,it turns off automatically (sleep mode).
Eraser
Roller
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.These limits are designed to provide reasonable protection
against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
FCC Note (United States Only)
Questions? We'd like to hear from you!
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment, please call 1-800-382-7470.
Or,write to:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
For other countries,outside the United States:
Canada: call 1-800-567-7724,or write to: Mattel Canada Inc, 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.
Great Britain: telephone 01628 500302.
Australia: Mattel Australia Pty.Ltd., 658 Church Street,Locked Bag #870,Richmond,
Victoria 3121 Australia.Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive,Albany 1331,Auckland.
Consumer Information
Fisher-Price,Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2002 Mattel, Inc.All Rights Reserved. ® and ™ designate U.S.trademarks of Mattel, Inc.
Printed in China 73437b-0920
Loading...