Page 1
Sparkling Symphony
Soother
Sparkling Symphony
Soother
Sparkling Symphony
Soother
™
with Remote Control
Model Number 73431
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Please keep this instruction sheet for future reference, as it contains important information.
Requires four “C” (LR14) alkaline batteries in soother and two “AA” (LR6) alkaline batteries in remote.
(Batteries not included.)
Tool required for battery installation: Phillips screwdriver (not included).
Batteries must be installed by an adult.
Page 2
Remote Features
Remote Features
Soother Features
Soother Features
Carry Handle – Sturdy carry handle allows you or your
child to take the soother wherever you go!
Receiver Dome – Blinks when it is ready to accept a signal
from the remote. Dome rotates to align with the transmitter on
the remote.
Mode Switch – Use to turn the soother ON and select any
one of three play modes: Short Play, Long Play, or Long Play
Without Lights and to turn the soother OFF.
Heart Button – Press to activate the soother when the mode
switch is in any of the three play positions.
Volume Control – Adjust volume to a comfortable listening level.
Speaker – Allows baby to hear soothing lullabies or sound effects.
Fastener Strap – To easily attach the soother to a crib.
Fastener Cord – Ties to crib rail to keep the soother in place.
Battery Compartment – Insert four “C” alkaline batteries.
Fastener Strap Storage Slot – Slide the ends of the fastener
straps into the slots to secure the straps when the soother is
not attached to a crib.
Rear
Front
1
10
7
8
9
7
1
2
3
4
5
6
7
8
9
10
10
4
3
6
5
2
2
CAUTION
Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to
a crib or playpen according to the instructions. Check frequently.
Button – Press to activate when the receiver on the soother
is blinking.
Please note: If the receiver on the soother is not blinking,
the soother is not ready to accept a signal from the remote.
LED Signal Indicator – Lights when the button is pressed
to let you know the remote has transmitted a signal.
Transmitter Window – Sends a signal to the receiver on
the soother.
Handle – Flips up so you can hang the remote on a
door knob. Snaps around bottom of remote when not in use.
Battery Compartment – Insert two “AA” alkaline batteries.
®
Rear
Front
1
1
2
3
4
5
3
4
4
5
2
Page 3
Battery Tips
Battery Tips
Battery Installation
Battery Installation
3
Soother
• Locate the battery compartment door on the back of
the soother.
• Loosen the screws in the battery compartment door with a
Phillips screwdriver.
• Open the battery compartment door and insert four “C” (LR14)
alkaline batteries, as indicated in the battery compartment.
• Close the battery compartment door and tighten the screws
with a Phillips screwdriver. Do not over-tighten.
Note: Under normal use conditions, the batteries in the soother
will require replacement more often than the batteries in the
remote. When you notice that the sound slows down and is
affected by the light display or when the sound or lights become
faint, it’s time to replace the batteries in the soother.
Battery Compartment
Soother
Remote
Remote
• Locate the battery compartment door on the back of
the remote.
• Loosen the screw in the battery compartment door with a
Phillips screwdriver.
• Open the battery compartment door and insert two “AA” (LR6)
alkaline batteries, as indicated in the battery compartment.
• Close the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
IMPORTANT! If the soother does not respond to use of the
remote it does not necessarily mean that the battery power in
the remote is low. Replace the batteries in the remote if the
LED signal indicator on the remote is dim when the button
is pressed. If the LED signal indicator does not light after
installing new batteries in the remote, check the orientation
of the batteries in the battery compartment to make sure they
are properly installed.
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product and dispose
of them safely. Battery leakage and corrosion can damage
the product. Dispose of batteries properly.
• Do not dispose of batteries in a fire. The batteries may
explode or leak.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in the “Battery Installation” instructions
are to be used.
• If removable rechargeable batteries are used, they are only
to be charged under adult supervision.
• Rechargeable batteries are to be removed from the product
before they are charged.
• Battery chargers used with the toy must be examined
regularly for damage to the cord, plug, enclosure and other
parts. In the event that such damage is found, the toy must
not be used with the battery charger until the damage has
been repaired.
This product requires four “C” alkaline batteries in
soother and two size “AA” alkaline batteries in remote
for operation. For longer battery life, use only
alkaline batteries.
Shown Actual Size
1.5V x 4
“C” (LR14)
1.5V x 2
“AA” (LR6)
Page 4
Soothing Music!
Soothing Music!
Attaching the Soother to a Crib
Attaching the Soother to a Crib
4
• Position the soother against the crib rail with the front of
the soother facing the interior of the crib.
• Wrap the fastener straps over the top of the crib rail.
• Fit a slot in each strap over the peg on the back of the
soother. Make sure the receiver dome on the soother is
above the crib rail so that the crib rail will not obstruct
the direct line between the remote transmitter and the
soother receiver dome.
• Tie the cord on the back of the soother around the nearest
side rail.
Cord
Fastener Strap
Peg
Peg
Remote
Pocket
Receiver
Dome
Crib Rail
IMPORTANT!
• In the unlikely event that use of the remote interferes with
normal use of other remote controlled equipment, such as
televisions and stereos, or use of other electric or battery
powered appliances interfere with operation of this product,
do not use both appliances at the same time.
• For best performance between the soother and the remote,
avoid using Slumbertime Soother with Remote Control in
areas of bright light. In bright natural or artificial light you
may notice loss of range when using the remote. Move
the soother or otherwise reduce the amount of light to
improve performance.
• Use the mode switch (behind the carry handle) to turn the
soother ON and select any one of the three play modes:
Short Play Long Play and Long Play without Lights .
The receiver will blink to indicate it's ready to receive a signal
from the remote.
• Activate the soother by pressing the heart button on the front
of the soother or by pressing the button on the remote. The
remote will activate the soother from one foot to as far as
20 feet away.
Mode Switch
Button
Heart Button
Mode Switch
®
• The receiver on the soother and the transmitter on the remote
must be in a direct line and free of obstructions to function
properly. Choose a location along the crib rail to attach the
soother that will allow you to easily use the remote.
®
Page 5
Short Play Mode
Short Play Mode
Long Play Mode
Long Play Mode
Long Play Mode without Lights
Long Play Mode without Lights
Soothing Music!
Soothing Music!
IMPORTANT! When using the remote, make sure that the
arrow on the soother’s receiver dome is pointing towards the
transmitter on the remote. For best results, make sure the
receiver dome is above the crib rail so that the crib rail will
not obstruct the direct line between the remote transmitter
and the soother receiver dome. Rotate the receiver dome
so that the arrow on the dome points to the area from
which you’re most likely to use the remote. For example,
if you’ll most often be using the remote from the doorway of
the nursery, make sure that the arrow on the receiver dome
is pointing towards the doorway and that the path between
the receiver and the doorway is free from obstructions.
Choose any one of 10 calming songs (five lullabies and five
classical tunes). The song plays to a gentle light display
featuring cute crib friends.
• Press the button on the soother or the remote to play the first
song and start the gentle light display. To skip to a different
tune, press the button to stop the first song. Press the button
again to start the second selection. Keep pressing the button
to cycle through all 10 songs.
• When the selected song ends, the receiver remains active
and will blink for up to 30 minutes. Press the button on
the soother or the remote to start the next tune. After
approximately 30 minutes without activation, the receiver
times-out and will stop blinking. Press the heart button on
the soother to restart the first song and light display and
reactivate the remote. Or, to reactivate the remote without
restarting the music and light display, move the mode switch.
Plays a medley of 10 different relaxing lullabies and classical
tunes for approximately 10 minutes to a gentle light display
featuring cute crib friends.
• Press the button on the soother or remote at any time during
play to stop the music and light display.
• When the medley ends, the receiver remains active and will
blink for up to four hours. Press the button on the soother or
the remote to restart the medley. After approximately four
hours without activation, the receiver times-out and will stop
blinking. Press the heart button on the soother to restart the
medley and light display and reactivate the remote. Or, to
reactivate the remote without restarting the music and light
display, move the mode switch.
Operates the same and plays the same musical medley as
the regular long play mode but without lights.
®
Receiver Dome
Transmitter
Window
Receiver
Dome
5
Page 6
FCC Statement (United States Only)
FCC Statement (United States Only)
Care
Care
Consumer Information
Consumer Information
Take-Along Fun
Take-Along Fun
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.
©2001 Mattel, Inc. All Rights Reserved. Printed in China
® and ™ designate U.S. trademarks of Mattel, Inc. 73431a-0920
Questions? We'd like to hear from you!
Call Fisher-Price
®
Consumer Relations, toll-free at
1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment, please
call 1-800-382-7470. Or, write to: Fisher-Price
®
Consumer
Relations, 636 Girard Avenue, East Aurora, New York 14052.
For other countries, outside the United States:
Canada: call 1-800-567-7724, or write to: Mattel Canada Inc.,
6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
Great Britain: telephone 01628 500303.
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
CAUTION: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user's authority to operate the equipment.
• This toy is portable for take-along fun and can be used long
after your child outgrows the crib!
• Fit the top slot in each strap over the peg on the back of
the soother.
• Fit the end of each strap into each storage slot in the back of
the soother to secure the strap ends.
Top Slot
Storage Slot
Peg
• Always turn the mode switch to the OFF position when the
soother is not in use.
• Do not leave the remote face down or in a drawer or toy box.
Light pressure on the remote button can activate the remote
and drain the batteries.
• To clean, wipe the surface of the soother and remote with a
damp cloth. Do not immerse the soother or remote.
Loading...