Firstech, LLC. RF-2WG9R-SP Quick Start Card

QUICK START CARD

8102REUCL000400 // REV1

RF-2WG9R-SP

Tap the Lock Button to lock your doors and/or arm your vehicle. Hold this button for 3.5
seconds to activate panic/vehicle locater.

Tap the Unlock Button to unlock your doors and/or disarm your vehicle.

Hold this button for 2.5 seconds to pop your trunk. If not equipped, ask your Authorized
Dealer for details on how to get it.

Hold this button for 2.5 seconds to start your vehicle. Your remote’s LED will blink showing
the remote start run time. Repeat and your vehicle will shut off.

Auxiliary 1: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Trunk
release button.

Auxiliary 2: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Start
button.

Tap these two buttons at the same time to turn Valet Mode off. Turn Ignition On and
tap buttons to turn on. Hold them for 2.5 seconds to turn your FT-DAS or Shock
Sensor on or off.

Tap these two buttons at the same time to turn the horn or siren chirps on or off.

Tap these two buttons to activate Passive locking/arming. Your system will lock/arm
after 30 seconds if enabled. Hold these two buttons for 5 seconds to activate 2nd Car
Mode. Your LED will switch from amber to red. *Red LED denotes 2nd Car Mode.

2W4BLED_QuickCard.indd 1 2013/6/6 11:14:43

QUICK START CARD

EVENT LEDS

Runtime Remaining: 100% Green Flash
Runtime Remaining: 50% Amber Flash

Runtime Remaining: 60 Sec. Red Flash
All Command Confirmations Green Flash 1 or 2 1 or 2
All Error Confirmations Green/Red Flash
Arming/Locking While Trigger

is Open

Red Flash

LED

DURATION

Once Every

6 Seconds

3 Times 3 Times

Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
or turn the Ignition On and then tap the foot brake 10 times or
reprogram your remote(s).

To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.

REMOTE

CHIRPS

6 Times

N/ARuntime Remaining: 25% Red Flash

RF-2WG9R-SP

START ERROR CODESLEDS

PARKING LIGHT FLASHES REMOTE START ERROR

3 then 1 1: Motor running
3 then 2 2: Key in ignition on position

3 then 3

3 then 4 4: Trunk open
3 then 5 5: Foot brake on
3 then 6 6: Hood open

3 then 7

3 then 8 8: Tach or voltage sensing failure
3 then 9 9: FT-DAS sensor shutdown

3 then 10 10: System is in Valet Mode

Register online at www.compustar.com within 10 days of
purchase to activate your new remote’s warranty.

Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user’s manual.

3: Door open
(manual transmission only)

7: Reservation off
(manual transmission only)

2W4BLED_QuickCard.indd 2 2013/6/6 11:14:43