First Alert FORAY MSDS
1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING
1.1. Identification of the preparation
Product Name: "PLUS-FIFTY C"
Chemical Name: N/A – This is a mixture/preparation.
CAS No.: N/A – This is a mixture/preparation.
Chemical Formula: N/A – This is a mixture/preparation.
EINECS Number: N/A – This is a mixture/preparation.
1.2. Use of the preparation
The intended or recommended use of this preparation is as a FIRE EXTINGUISHING AGENT.
1.3. Company identification
Manufacturer/Supplier: ANSUL INCORPORATED
Address: One Stanton Street, Marinette, WI 54143-2542
Prepared by: Safety and Health Department
Phone: 715-735-7411
Internet/Home Page: http://www.ansul.com
Date of Issue: September, 2009
1.4. Emergency telephone
CHEMTREC 800-424-9300 or 703-527-3887
2. COMPOSITION/INFORMATION ON INGREDIENTS
2.1. Ingredient Name: Sodium Bicarbonate.
Chemical Formula: NaHCO
3
.
CAS No.: 144-55-8.
EINECS Number: 205-633-8.
Concentration, Wt %: 90-92 %.
Hazard Identification: See Heading 3.
Ingredient Name: Talc.
Chemical Formula: Mg
3H2
(SiO3)4.
CAS No.: 14807-96-6.
EINECS Number: 238-877-9.
Concentration, Wt %: <5 %.
Hazard Identification: See Heading 3.
Ingredient Name: Magnesium Aluminum Silicate (Attapulgite Clay or Fuller’s Earth).
Chemical Formula: Mg
xAly
(SiO3)z.
CAS No.: 8031-18-3.
EINECS Number: (b).
Concentration, Wt %: <4 %.
Hazard Identification: See Heading 3.
Ingredient Name: Methyl Hydrogen Polysiloxane.
Chemical Formula: Mixture/preparation.
CAS No.: 63148-57-2.
EINECS Number: (a).
Concentration, Wt %: <0.2 %.
Hazard Identification: See Heading 3.
Ingredient Name: Blue Pigment (Hostaperm Blue).
Chemical Formula: C
32
H16CuN8.
CAS No.: 147-14-8.
EINECS Number: 205-685-1.
Concentration, Wt %: <0.1 %.
Hazard Identification: See Heading 3.
PLUS-FIFTY C MATERIAL SAFETY DATA SHEET
CONFORMS TO DIRECTIVE 2001/58/EC
ANSUL
®
ANSUL INCORPORATED
MARINETTE, WI 54143-2542
[2.2. (i) There are NO substances presenting a health or environmental hazard within the meaning of Directive 67/548/EEC, in
concentrations equal to or greater than those laid down in the table set out in Article 3(3) of Directive 1999/45/EC, nor
with lower limits given in Annex I to Directive 67/548/EEC or in Annexes II, III or V to Directive 1999/45/EC.
(ii) There are NO substances for which there are Community workplace exposure limits, which are not already included in
(i) above.]
(a) EINECS does not include synthetic polymers (these are registered in EINECS under their building blocks, monomers).
See: 67/548/EEC, article 13; 79/831/EC; and 81/437/EC.
(b) EINECS does not include most naturally occurring raw materials. See: 67/548/EEC, article 13; 79/831/EC; and
81/437/EC.
NOTE: Unless a component presents a severe hazard, it does not need to be considered in the MSDS if the
concentration is less than 1%. [According to Directive 1999/45/EC].
3. HAZARDS IDENTIFICATION
FOR HUMANS:
Product:
This preparation is not classified as dangerous according to Directive 1999/45/EC.
Limit Values for Exposure:
Nuisance dust limit: OSHA TWA: 15 mg/m
3
.
ACGIH TLV-TWA: 10 mg/m
3
.
Neither this preparation nor the substances contained in it have been listed as carcinogenic by National Toxicology
Program, IARC, or OSHA.
AS PART OF GOOD INDUSTRIAL AND PERSONAL HYGIENE AND SAFETY PROCEDURE, avoid all unnecessary
exposure to the chemical substance and ensure prompt removal from skin, eyes, and clothing.
SIGNS AND SYMPTOMS:
Acute Exposure:
Eye Contact: Mildly irritating for short periods of time.
Skin Contact: May be mildly irritating.
Inhalation: May be irritating to mucous membranes.
Ingestion: Not an expected route of entry.
Chronic Overexposure: Lungs, gastrointestinal, and kidney can be affected.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: None known.
FOR ENVIRONMENT:
No adverse effects expected.
4. FIRST AID MEASURES
Eye Contact: Flush with water for a minimum of 15 minutes while holding lids open. If irritation persists seek
medical attention.
Skin Contact: Wash affected area with soap and water. If irritation persists seek medical attention.
Inhalation: Remove from exposure. If irritation persists seek medical attention.
Ingestion: If patient is conscious, dilute by drinking large quantities of water.
5. FIRE-FIGHTING MEASURES
This preparation is an extinguishing media.
There are NO extinguishing media which must not be used for safety reasons.
NO special protective equipment is needed for fire-fighters. Wear protective equipment appropriate for the fire conditions.
6. ACCIDENTAL RELEASE MEASURES
For personal protection: Prevent skin and eye contact, see Heading 8.
Clean up: Sweep up and reuse or place in a closed container for disposal, see Heading 13.
NO harm to the environment is expected from an accidental release of this preparation.
Page 2PLUS-FIFTY C (Continued)
Loading...