Page 1
864TRV Arched Face
Part Numbers
Compatibility:
• 864TRV Fireplace
• 864 HH Fireplace
The FPX Face Upgrade Kit (98500686) must
be installed prior to installing the facing
material and face.
Installation
Details
• Classic Black 99300497 • Nickel 95800615
• Artisan 99300498 • Artisan Antique Copper 95800619 • Artisan Antique Nickel 95800620
• French Country 99300499 • French Country Black 95800616
Packing List:
• Face • (4) 8-32 Nuts
• (2) Face Mounting Brackets (w screws) • (2) 10-24 1-1/2" Screws
• Glass Frame Cover
5"
Radius = 45-3/4”
35-3/4"
41”
NOTE FOR THICK FACING (BRICK, ROCK, ETC.):
The Fireplace Xtrodinair 864 Set-Up Face is recommended for
masonry installation (98500688). The set-up face helps locate
and support the masonry during installation.
SIDE OF FIREPLACE
1”
5/16” TO 1”
NOTE:
This face has an adjustable bracket that allows for
different facing depths to be tucked under the face.
Page 1 of 4 5/3/07 © Travis Industries, Inc.
Page 2
864TRV Arched Face
Installation
1 Remove the glass frame (see the owner's manual for details). Install the glass frame cover following the
directions below. Replace the glass frame.
Place the cover over the top of the door frame.
Push these pins inwards
to lock the cover in place.
Page 2 of 4 5/3/07 © Travis Industries, Inc.
Page 3
864TRV Arched Face
2 The facing and hearth (if applicable) must be installed prior to attaching the face. See the installation manual
for complete details.
Raised
Fireplaces
Floor-Level
Fireplaces
Note how the tile is 1”
(maximum) above the
base of the fireplace.
Maximum 1`” Hearth
Page 3 of 4 5/3/07 © Travis Industries, Inc.
Page 4
3 Install the face following the directions below.
864TRV Arched Face
Attach the upper brackets
to the face with the
a
included nuts.
The face is secured to the fireplace
with four screws. Two of the screws
c
are fastened to the upper brackets
with press nuts. The lower screws
are included with the face.
Slide the face into place. The
tabs on the upper brackets insert
b
into the slots on the fireplace
brackets, holding the face in place
while the screws are tightened.
Plated Surfaces
Use denatured alcohol and a soft cloth to clean plated surfaces. Marks
left on the surface may damage the face.
Page 4 of 4 5/3/07 © Travis Industries, Inc.
Soft Cloth
Denatured
Alcohol
Loading...