FireplaceXtrordinair 564 E User Manual

564 E Matrix Face

95400488

Compatibility:

• 564 Electric Fireplace

Packing List:

• Matrix Face

• Heat Shield

Plated Surfaces

Use denatured alcohol and a soft cloth to clean plated surfaces. Marks left on the surface may damage the face.

Soft Cloth

Installation Notes

This face will not work with the Travis Mantel. The face extends 5/8” below the base of the fireplace and is 47” wide (too wide for the mantel). When building an enclosure for the fireplace, make sure to raise it a minimum 3/4” above the flooring surface (typically 18” or higher).

47”

Denatured

Alcohol

Face

SIDE OF

FIREPLACE

29-1/2”

5/8”

Re-Painting the Back Panels

This face has removable back panels that may be re-painted to suit your interior decor. They may be re-painted using high temperature paint (400° engine enamel paint). Prepare the surface using a Scotch-Brite ® pad to insure proper paint adhesion.

Page 1 of 2 9/18/07 © Travis Industries, Inc.

Installation

AAAA

NOTE: We recommend pulling the fireplace out a couple of inches while installing or removing the face to

insure the hooks on the face fully engage the slots on the fireplace.

1 Install the heat shield following the directions below.

Remove and discard the stock upper heat shield.

564 E Matrix Face

95400488

Attach the heat shield included with this kit (note position of the shield).

2 Attach the face following the directions below.

Lift the face up slightly, tilt it forward and insert the top hooks until the face locks in place.

Tilt the face back slightly and insert the bottom hooks into the slots on the fireplace.