WI-SAFE GATEWAY
Installation Guide
WG-1T
Available on all wireless products
INSTALLATION INSTRUCTIONS
1. The Gateway is designed to stand freely or be permanently secured to a wall.
2. Connect Ethernet cable here .
3. Connect Power cable here .
Remove the pin in the
centre hole to activate
the locking feature.
Break the three plastic
knockouts loose. Use the
supplied plastic anchors
and screws.
Make a note of the MAC address prior to permanent installation as you will need this
when activating the Gateway for the first time.
To remove the
Gateway: Insert a
screwdriver into the
hole until it stops,
releasing the lock.
Slide the Gateway
up to remove it.
SETTING UP THE WI-SAFE GATEWAY
1. Obtain log-in details from your account administrator/ distributor.
2. Access the installation Wizard: www.wi-safeconnect.com
3. Follow the online installation instructions.
www.wi-safeconnect.com
The WG-1 Gateway allows for all devices utilising Wi-Safe 2 wireless communication to
connect to the internet. The diagnostic information held within an individual WS2 device
is sent directly to a personalised cloud based dashboard, where alerts can be managed
and responses initiated.
Please note: an internet connection is required when setting up an alarm network for the
first time, in conjunction with the Gateway.
LIMITATIONS
The Wi-Safe 2 protocol is not a life safety protocol and
should not be relied upon for life safety. If your internet
connection is lost, communication from the WG-1T (i.e.
to cloud or mobile devices) may not be possible. The
local alarm network will still continue to operate as a
stand-alone system and does not rely on an internet
connection to do so.
WARRANTY
For information on individual alarm warranty please refer
to the main alarm manual.
Sprue Safety Products Ltd warrants to the original
purchaser that its enclosed WG-1T to be free from
defects in materials and workmanship under normal
residential use and service for a period of 2 (two) year
from the date of purchase. Provided it is returned with
proof of purchase date, Sprue Safety Products Ltd
hereby warrants that during the 2 (two) year period
commencing from the date of purchase Sprue Safety
Products Ltd, at its discretion, agrees to replace the unit
free of charge.
The warranty on any replacement WG-1T, will last for
the remainder of the period of the original warranty in
respect of the wireless module originally purchased –
that is from the date of original purchase and not from
the date of receipt of the replacement product.
Sprue Safety Products Ltd reserves the right to offer an
alternative product similar to that being replaced if the
original model is no longer available or in stock. This
warranty applies to the original retail purchaser from the
date of original retail purchase and is not transferable.
Proof of purchase is required. This warranty does
not cover damage resulting from accident, misuse,
disassembly, abuse or lack of reasonable care of the
product, or applications not in accordance with the
user manual. It does not cover events and conditions
outside of Sprue Safety Products Ltd’s control, such as
Acts of God (re, severe weather etc.). It does not apply
to retail stores, service centres or any distributors or
agents. Sprue Safety Products Ltd will not recognise any
changes to this warranty by third parties.
Sprue Safety Products Ltd shall not be liable for any
incidental or consequential damages caused by the
breach of any expressed or implied warranty. Except
to the extent prohibited by applicable law, any implied
warranty of merchantability or tness for a particular
purpose is limited in duration for 2 (two) year. This
warranty does not affect your statutory rights. Except
for death or personal injury, Sprue Safety Products Ltd
shall not be liable for any loss of use, damage, cost or
expense relating to this product or for any indirect or
consequential loss, damages or costs incurred by you or
any other user of this product.
DISPOSAL
Waste electrical products should not be disposed of
with your other household waste, but within the waste
electronic and electrical equipment (WEEE) recycling
scheme.
WARNING: Do not attempt to disassemble. Do not burn
or dispose of in re.
TECHNICAL
SPECIFICATION
The WG-1T gateway is designed to be installed
in conjunction with Wi-Safe 2 (protocol)
compatible devices. For more information visit
www.wi-safeconnect.com.
230V Mains Powered, 5V DC, 1.5A
Independently tested to:
EN 301 220-2 V 2.4.1
EN 301 489-3 V 1.6.1
EN 301 489-1 V 1.9.2
Manufacturer: Sprue Safety Products Ltd, Vanguard
Centre, Sir William Lyons Rd, Coventry, CV4 7EZ, UK
For more information visit:
www.wi-safeconnect.com
A Sprue Brand
Sprue Safety Products Ltd.
Vanguard Centre, Coventry CV4 7EZ UK
GN4511R2
Loading...