THE HEAT CONTROLLER
RADIATOR THERMOSTAT
Quick Start Guide
Scan the code to
read the manual
Support
If you need help configuring FIBARO The Heat Controller,
follow our guides and technical manuals available at:
manuals.fibaro.com/en/hk-heat-controller
2
Package Contents
Every FIBARO The Heat Controller has a unique HomeKit Setup Code.
You will find the setup code on back cover of the Quick Start Guide.
Quick Start Guide, Quick
Manuals, Warranty Terms
Adapters. Depending on type of your thermostatic valve:
M30 x 1.5
Danfoss RTD-N
Danfoss RA-N
Proceed normally
Use adapter
Use adapter
3
Device
Temperature sensor
(optional)
Maintenance key
FIBARO app
Download FIBARO application from the App Store.
homekit.fibaro.com/app
4
First launch
Step 1
Connect the charger to the micro-USB
port to charge the device
Fig. 1
Step 3
Dismount your current thermostatic
head
Fig. 3
Step 2
Disconnect the charger when the LED
ring pulses green (device fully charged)
Fig. 2
Step 4
Depending on type of your valve
proceed normally or use adapter
Fig. 4
5
First launch
Step 5
Mount the device on the valve and
tighten it by turning the cap clockwise
Fig. 5
Step 7
Open the FIBARO app
and tap Add accessory icon.
Application will guide you
through the pairing process
Add accessory
Fig. 7
Step 6
Use the included key to click the button
Button
Fig. 6
If you have already set up another
accessory tap the + icon
!
6
Resetting The Heat Controller to factory defaults
1. Use the included key to press and
hold the button. When the LED
ring glows yellow, release the button
2. Click the button again immediately
to confirm
3. The device will reset to factory
defaults and will be put in Standby
Mode. Click the button to activate
Fig. 8
it again
Sensor pairing
1. Use a coin to open the battery cover
by turning it counter-clockwise
2. Remove the sticker underneath
the battery. Use coin again to close
the battery cover
3. Press and hold the button on
The Heat Controller. When the LED
ring glows blue, release the button
and click again immediately to confirm
4. Click the button on the Temperature
Sensor, the LED diode will start
blinking blue
LED diode
Fig. 9
5. The LED ring on The Heat
Controller, will blink green 5 times
if the connection was successful
7
HomeKit Setup Code is needed to securely add accessory
Remember to keep it in safe place. Nobody but you has a copy.
FIBARO cannot recover the HomeKit setup code for you.
© Fibar Group S.A.
All rights reserved
Made in Poland
www.fibaro.com
to your home. You may need it in case of re-pairing.
Room: ..........................................
Write down the location of the device.
105449610101
Loading...