Important directions for safety and the environment
1.1
For your safety
PRUDENZA:
NON FISSARE LA LAMPADA IN FUNZIONE.
PUÒ ESSERE DANNOSO PER GLI OCCHI.
CAUTION:
DO NOT STARE AT OPERATING LAMP.
MAY BE HARMFUL TO THE EYES.
Product tested in accordante with EN62471
Notes
Recommendations for correct
use of the appliance
Risk Group 2
B09001301
If this appliance is replacing an existing appliance which must be
removed or disposed of, make sure that it does not become a dangerous trap for children by cutting its power supply cable and rendering it impossible to close the door. Use the same caution at the
end of the lifespan of the new appliance.
This appliance is designed to refrigerate beverages and foods and
is intended for domestic use.
The appliance must be installed by following the instructions in the
Installation Guide, particular care should be taken not to obstruct the
vent openings of the appliance and of the built-in units.
The appliance features a concentrated lighting system with LED
lamps. Do not stare into these lamps when they are on to avoid possible eyesight damage.
This warning is also contained on the label attached to the inside of
the refrigerator door.
When the freezer is functioning do not touch the inner surfaces in
stainless steel with wet or damp hands, since skin may stick to the
very cold surfaces.
Do not use any type of electrical equipment inside of the food
conservation compartments.
When positioning the shelves, do not place fingers in the shelf
slide guides.
Important
Directions for avoiding
appliance damage
Warning
Indications for avoiding injury
to people
Do not position containers of flammable liquids near the appliance.
Completely switch off the appliance and unplug the power supply
cable during cleaning operations. If the plug is not easily reached, it
is a good idea to turn off the breaker or remove the fuse that controls
the socket that the appliance is connected to.
The packaging parts can be dangerous for children: do not allow
children to play with the plastic bags, plastic film or Styrofoam.
Any repairs must be performed by a qualified Fhiaba Service
technician.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or lack of experience and knowledge
unless they have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
Do not damage the appliance refrigerant circuit pipes.
Do not store explosive substances such as aerosol cans with a flam-
mable propellant in this appliance.
Important directions for safety and the environment
1
Caring for the environment
Pay special attention to correct disposal procedure for all the pack-
aging materials.
The appliance must not be disposed of with urban waste. Contact lo-
cal waste disposal centers for on how to dispose of recyclable waste.
Prior to disposal, cut the power supply cord and make it impossible
to close the door.
During disposal, avoid damage to the refrigeration circuit.
The appliance does not contain hazardous substances for the atmos-
pheric ozone layer, neither in the refrigeration circuit nor in the insulation.
Cleaning, sanitization and maintenance of the ice and/or water dispenser (if present)
Failure to follow the instructions regarding sanitizing can compromise
the hygienic safety of the water dispensed.
When using the appliance for the first time and every time the filter
is changed, it is recommended to let the water flow in the circuit using
the “Manual Cleaning” and discard the ice produced in the first 24
hours.
1.2
1.3
If the water dispenser has not been used for more than 4/5 days, it is
advisable to clean the circuit and run off the first litre of water.
Reposition the removable water dispenser (if present), ensuring your
hands are hygienically clean.
Clean the ice bucket or drawer regularly but using only drinking
water.
The filter must be changed when indicated on the control panel
or when the ice/water dispenser has not been used for more than 30
days.
With each filter replacement, sanitise the ice and/or water distribution system using a food grade disinfectant (with sodium hypochlorite), which does not alter the characteristics of the materials, or use
the “Sanitising Kit” available from the After-Sales Service. Rinse with at
least 2 litres of water before use.
Only original spare parts supplied by the manufacturer should be
used when replacing components in the ice and water dispenser.
Any work on the appliance must be carried out by a qualified technician or the After-sales Service.
Do not use extension cords and/or multiple adapters for the power supply connection.
If energy is supplied through an alternative energy power source (solar, geothermal, etc..) or if home automation
systems are installed, it is necessary to
install the Alternative Energy Kit to integrate the unit into the power grid.
Make sure that installation is performed correctly, adhering to all directions in the specific installation manual provided with the appliance.
The appliance is equipped with a Schuko type 16A plug and must be
connected to the electrical power supply through a corresponding
Schuko socket.
Do not use extension cords and/or multiple adapters for the power
supply connection.
The appliance should be supplied only
with drinkable water.
Make sure that installation is performed
correctly, according to all of the directions
in the specific installation manual provided with the appliance.
Connection to the water system
The models provided with Ice Maker require a connection to the domestic water supply system. This can be executed through the provided water hose with 3/4” threading.
The system pressure must be between 0.05 MPa and 0.5 MPa (between
0.5 Bar and 5 Bar).
Differents pressures can cause malfunctions or leaks in the water system. The appliance should be supplied only with drinkable water.
2.3
Do not attempt to use a locally sourced
garden hose threaded adapter or braided supply line. It will strip the threads on
the appliance water connection solenoid.
Congratulations for having purchased your new Fhiaba:
from now on you can use our innovative conservation system, which will allow you to keep all of your food in the
best way possible.
This manual will answer most of your questions about the
product’s features. Should you require further information,
please check our website
www.fhiaba.com
or write us an e-mail at
care@fhiaba.com.
Before calling, write down the model type and serial
number which are available on the warranty certificate
and on the rating plate located on the bottom left-hand
corner of the appliance, behind the bottom drawer and
any messages which may have appeared on the display.
+39 0434 420 160
3.2
Exclusive design by Giugiaro
The Fhiaba TriMode refrigeration system and the efficient
separation of internal compartments ensures maximum
freshness and offers excellent conservation of foods in the
three compartments: refrigerator, Crisper-Fresco and freezer
It is also possible, should there be a need, to further increase the flexibility of the appliance by making the freezer
compartment operate as a refrigerator or as a Crisper-Fresco compartment
The Crisper-Fresco compartment has a low temperature
and controlled humidity, providing excellent conservation in
superior preservation conditions for fresh foods
Electronic control guarantees constant temperature and
humidity levels set by the user and provides real-time compartment temperature readings.
An interactive menu (Menu) allows customized management of appliance functions and the visualization of functioning messages
Power save features to reduce consumption during vaca-
tion periods
Main features
Ample drawer space with Soft self-closing systems in the Crisp-
er-Fresco area
Ice Maker for automatic ice production of variable cube
size
Easily replaceable water filter located inside the refrigera-
tor
Patented adjustable shelf system, with shelves that can be
positioned at any level inside of the refrigerator without having to be removed
Stainless steel surface both inside and outside, with fine
aluminum trim
Patented hinge system that permits automatic door closing
External drawers with to self-closing system
Localized lighting with LEDs
Anti-tipping system by means of wall mounting brackets
The innovative electronic control system designed by Fhiaba maintains constant temperature on the three compartments and visualizes it on the control panel display.
It also allows user interaction making it possible to personalize settings of the various functions and to receive sound and/
or visual messages should occur any malfunction in the appliance.
Componenti principali
Main control panel
UNIT
FR
IDG
E
123456798
1
Unit
Switches the appliance (all compartments) between ON and STAND BY
(press for three seconds).
ICE MAKER
E
NT
E
R
3
3.3
3.4
3.3
3.5
2
3
4
5
Fridge
Menu
Up/down
Fridge
Display
Up/Down
6
Freezer
(TriMode)
7
8
9
Enter
Ice maker
Alarm
Allows switching on and off of only the refrigerator compartment
(press for three seconds).
Allows access to the appliance function menu
Using the Up and Down buttons, it is possible to change the set temperature of the refrigerator and navigate through the interactive menu.
It shows the temperature of the refrigerator and freezer compartments,
the date and time, Menu functions and visual messages.
By selecting Up/Down the preset temperature can be changed according to the selected function mode (freezer, refrigerator, Fresco).
Confirms activation or deactivation of the selections made in the
Menu.
Allows activating or deactivating the automatic ice production.
Blinks to signal user alerts such as door left open, also in combination with
a sound signal which can be deactivated by pressing the button.
11
12
13
Display
Up/Down
Crisper
Componenti principali
Fresco control panel
CRIS
P
E
R
101112
Shows the temperature of the Fresco compartment.
Using the Up and Down buttons, it is possible to change the temperature set for the Fresco compartment.
Allows switching on and off of only the Fresco compartment (press
for three seconds).
When the appliance is connected to the electrical power supply but
has not yet been switched on, the display shows the message
Tis is a safety message to warn that the appliance is connected to the
mains, and all the panel buttons are off.
To switch on all the appliance compartments, press the Unit button
for three seconds.
When the appliance is first switched on the TriMode compartment is
set to the “freezer” mode. After switching on it remains always on and
can be switched off only by switching off the complete appliance.
Press Unit
Use the same buttons to restart.
The freezer compartment always stays on and cannot be switched off
except by completely switching off the appliance by pressing the Unit
button for three seconds.
During long absence periods it is recommended to switch off the refrigerator by pressing the Unit button
electrical plug or the breaker controlling the socket.
for three seconds.
for three seconds and disconnecting the
If at the first startup the Standby message does not
appear, but another message appears, it means
that the appliance has already started the cooling
process. If this is the case, deactivate any possi-
ble sound signal by pressing the Alarm button
close the door and wait until the set temperature
is reached.
During the first startup, it will not be possible to use
the Menu to modify the factory settings until the
preset temperature has been reached.
Each time the appliance is switched on it goes
trough a self-diagnosis procedure lasting three
minutes before completely starting up.
If only the refrigerator compartment or the Fresco
compartment is switched off, the specific fan will
continue to operate to prevent the formation
of unpleasant odors and mold.
Completely empty the refrigerator, clean and dry it and leave the doors
and drawers partially open to prevent unpleasant odors.
,
Before switching off the appliance for a long period of time, remove all of the items inside and
leave the doors and drawers open to prevent the
formation of unpleasant odors and mold.