Fetco L4S-20 User Manual

Page 1
LUXUS® L4D & L4S Thermal Dispensers
L4D-10 L4D-15 L4D-20
1 gallon 1½ gallon 2 gallon
© 2017 Food Equipment Technologies-FETCO® 600 Rose Rd. Lake Zur ich, IL 60047-0429 USA : (800) 338-2699 or (847) 719-3000 website: www.fetco.com email: info@fetco.com
PATENTED PATENTS: WWW.fetco.com/patents P157 March 2017
Page 2
BREW FUNNEL DISPLAY
Freshness Timer
Quad icons, each divided into quarter hours segments—The
four icons represent a time
range of four hours
1-15…minute time range
16-30…minute time range
…Some displays are
omitted for clarity
Slowly pulsing display:
…more than 4 hours
Time is reset when dispenser is completely emptied, when funnel is removed, or when enough liquid is added to increase the volume by at least one level
FUNNEL DISPLAY
®
FETCO indicator funnel
Blank indicator funnel display is
shown, dispenser is “Ready” for
brewing
BLANK: Empty—Ready To Brew
…Active On & Off…
NO DISHWASHER
NO MICROWAVE
Clean and dry funnel
by hand only
Volume Indicator
Lower “VEE”+ four upper
bars represent 20%
increments of fill level of
the dispenser
”READY” TO BREW”
Fifth Level-FULL
Fourth Level=80%filled
Third Level= 60% filled
Second Level=40% filled
First Level=20% filled
DISPENSER EMPTY
Page 3
Do not submerge Brew funnel must be removed for
Removing the funnel resets timer.To extend battery life, remove the
TO ACCESS BREW FUNNELRemove both plug and bail handle-Snap cover out at OPEN hinge knuckle-Squeeze funnel bail inward at knuckles
TO REMOVE FUNNEL ASSEMBLY
NOTE: NEVER carry dispenser by the bail handle
-Swing large carrying handle to rear
-Lift funnel by small bail handle
Important Notice: To maintain proper operation of the funnel display, clean the funnel stem daily under running water with detergent and sponge, or non-abrasive pad or towel.
manual filling of dispenser.
funnel when not in use. (Battery cannot be replaced. )
to remove
Maintaining The L4 Funnel
Page 4
Accessing Dispenser Parts
REMOVING THE DRIP TRAY REMOVING THE FAUCET GUARD REMOVING THE FAUCET
1) Unscrew knob approximately four turns
2) Slide faucet guard out.
Slide drip tray out release latch up.
latch release Press faucet
knob
and pull it out
replace seat cup to lock faucet into place--!!Click!!
Rotate fa ucet 180°
Unscrew faucet upper Reverse procedure to re-install
assembly to clean or faucet. Press release latch down
Page 5
Page 6
Replacement Parts
Page 7
Dispenser Model Number
g
p
(
# Description L4D10 & L4S10 L4D15 & L4S15 L4D20 & L4S20
1A Cover Lid
1023.00277.00 1023.00277.00 1023.00277.00
1B Funnel Bail Handle
2 Funnel Top Cover
3 Handle With Hardware 4A Top Gasket 4B Bottom Gasket 4C Neck Gasket
5 Cover/ Funnel Assembly
6 Top L4D
7 Indicator Funnel
Faucet Upper Assembly
8
(Standard-Black) Faucet Upper Assembly
8
Oran Faucet Upper Assembly
8
Green Handle Faucet Upper Assembly
8
Blue Handle
9 Faucet Handle, Black
Faucet Handle, Red
9
HOT WATER”
10 Faucet Seat Cup 11 Faucet Body Assembly.
Faucet Assembly
12
Com
13 Faucet Guard
Knob & Washer
14
For Faucet Guard)
15 Drip Tray Assembly 16 Faucet Lock 17 Insert, Bottom 18 Bottom L4D 19 Stand Assembly. 20 Anti-Slip Foot (Qty-4) 21 Funnel Plug (Qty-4)
e Handle“DECAFF”
lete
1023.00278.00 1023.00278.00 1023.00278.00
1023.00283.00 1023.00279.00 1023.00279.00
1000.00111.00 1000.00112.00 1000.00112.00
1029.00014.00 1029.00016.00 1029.00016.00
1029.00013.00 1029.00015.00 1029.00015.00
1024.00070. 00 1024.00070. 00 1024.00070. 00
1109.00109.00 1102.00347.00 1102.00366.00
1023.00286.00 1023.00282.00 1023.00282.00
1102.00142.00 1102.00149.00 1102.00175.00
1071.00020. 00 1071.00020. 00 1071.00020. 00
1071.00030. 00 1071.00030. 00 1071.00030. 00
1071.00031. 00 1071.00031. 00 1071.00031. 00
1071.00032. 00 1071.00032. 00 1071.00032. 00
1071.00022. 00 1071.00022. 00 1071.00022. 00
1071.00040. 00 1071.00040. 00 1071.00040. 00
1071.00013. 00 1071.00013. 00 1071.00013. 00
1000.00012. 00 1000.00012. 00 1000.00012. 00
1102.00055. 00 1102.00055. 00 1102.00055. 00
1023.00076. 00 1023.00055. 00 1023.00055. 00
1000.00010. 00 1000.00010. 00 1000.00010. 00
1000.00013. 00 1000.00014. 00 1000.00014. 00
1023.00069. 00 1023.00069. 00 1023.00069. 00
1023.00083. 00 1023.00067. 00 1023.00067. 00
1102.00363. 00 1102.00361. 00 1102.00361.00
1000.00015. 00 1000.00016. 00 1000.00016. 00
1024.00069. 00 1024.00069. 00 1024.00069. 00
1029.00010.00 1029.00010.00 1029.00010.00
Page 8
IMPORTANT SAFEGUARDS To prevent overflows, make sure the dispenser is completely
empty before brewing.
Always remove the funnel for manual filling of the dispenser. Use only the large handle to lift or carry the dispenser.
NEVER use the small funnel bail to lift or carry the dispenser Do not use the faucet guard to pull or lift the dispenser. Do not submerge the brew funnel Do not use bleach or cleaners containing chlorides. Do not use solvent based cleaner or polish on this equipment Never use a cleaner on any food equipment that contains the
solvent diethylene glycol butyl ether (DGBE) .
Use only non-metallic brushes and non-abrasive cleaning pads. CLEANING AND MAINTENANCE
Detailed instructions are available on our web site, www.fetco.com.
Daily:
Important Notice: To mainta in proper operation of the funnel display, clean the funnel stem daily under r unning water with detergent and a non-abrasive sponge or towel. DO NOT SUBMERGE FUNNEL OR DISPENSER.
Use any commercial beverage urn cleaner to clean the inside of the
dispenser. Follow the cleaner manufacturer’s instructions. Make sure to thoroughly rinse the dispenser after cleaning.
Wash the drip tray and other plastic parts with dish detergent.
Avoid abrasives.
To sanitize the dispenser before filling, brew a batch of water only
(no coffee) into the dispenser and allow it to rest for 10 minutes.
Weekly, or as needed: Remove the faucet upper assembly and inspect the seat cup for
wear. Clean or replace if necessary.
Loading...