Page 1
CESM-TR3
Lifting kit for motor support for TR3
CSM-TR
SM-TR
SQ-29200
AC-657
x4
AC-654
x4
STEP 1
Place the four TR3 towers at the corner to mount
the truss perimeter and stabilize the towers.
STEP 2
Place horizontally the stair-truss that you want to
raise just above the perimeter, mount the top at
the end of the stair-truss and attach it to the two
hinges from the 0,5m truss. Make the same in the
4 towers.
STEP 3
Assembly all items for the support motor as
shown in the pictures, place the electrical chain
hoist and pass the chain. Ensure the hook to the
stair-truss using a sling or similar product.
TI-CSM
AP-CSM
Page 2
6°
STEP 4
Switch on the electrical chain hoist and
raise the stair-truss from horizontal to
vertical position. To easily lift the stairtruss, it is required to raise it manually up
to 6º in horitzontal position. Afterwards,
switch on the electrical chain hoist.
STEP 5
Once the tower is up, put the safety pins to
the hinges, remove the truss along with the
following accessories: CSM-TR, TI-CSM and
AP-CSM. Assembly SM-TR to the clamps of
the sleeveblock, as shown in image. Once
this step is done, you can start raising the
structure.
Loading...