
 FENDER® ACOUSTASONIC™ ULTRAL IGHT STEREO LOUDSPE AKER ENCLOSURE
Your new Acoustasonic™ Ultralight stereo loudspeaker features two 8" 
(20.3 cm) Eminence® woofers with neodymium magnets and two 1" 
(2.5 cm) soft dome tweeters with neodymium magnets, handling 
up to 250 watts of power. Designed to complement the Fender® 
Acoustasonic™ Ultralight amplifier, the Ultralight speaker cabinet is 
constructed from quality Italian poplar plywood. Please read these 
instructions and your amplifier manual before making connections.
  Ultralight Connections
To connect the Acoustasonic™ 
Ultralight speaker to an Ultralight 
amplifier, use the Speakon® cable 
included with the amplifier. Rotate 
the Speakon® connector to align it 
with the input slots, then fully insert 
the connector.
Rotate the connector clockwise until it 
locks into place. 
  Disconnecting
Slide the locking tab back on the 
connector while rotating the connector 
counter-clockwise. Pull the connector out 
from the input socket. 
Non-Speakon® Connections
If your amplifier does not have a 
Speakon® speaker output, you will need 
the appropriate speaker cable or adapter 
to connect the Acoustasonic™ Ultralight 
loudspeaker. Speaker cable should be 
4-conductor, 18–gauge minimum with 
the Speakon® connector wired: 
SPECIFICATIONS
PART NUMBER  2271700000
SPEAKERS    Two 8" (20.3 cm) drivers with 2" (5.1 cm) voice coils 
      and Neodymium magnets;
      Two 1" (2.5 cm) soft dome tweeters 
      with Neodymium magnets
CROSSOVER
      filter, using metallized polyester film capacitors and 
      low loss inductors
CABINET    5/8" (1.6 cm) Italian poplar plywood
SENSITIVITY    91 dB, 1 watt - 1 meter
POWER HANDLING  125 watts per side
IMPEDANCE    4 ohms per side
CONNECTIONS  4-Pole Speakon® connector 
ENCLOSURE VOLUME V
DIMENSIONS
    Height: 15 in  (38.1 cm) 
    Width:  20.25 in  (51.4 cm) 
    Depth:  10 in  (25.4 cm)
WEIGHT    22 lb   (10.0 kg)
   3kHz, 12dB/octave low-pass filter, 18dB/octave high-pass
B
 = 0.43 ft
3  
(12 L) per side
Product specifications are subject to change without notice.
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA USA
  1+ pin = Right [+] 
  1– pin = Right [–] 
  2+ pin = Left [+] 
  2– pin = Left [–] 
P/N 069327 REV A
®
 and Acoustasonic™ are trademarks of FMIC.
Fender
Other trademarks are property of their respective owners.
© 2005 FMIC. All rights reserved.