..................................................
..................................................................................
........................................................................................
.............................................................................
.................................................................
PERATI
*Only use a non-aerosol vegetable oil in long nozzle container
This shredder has a Control/Disconnect Power Switch (D) that must be in the ON (I) position to operate shredder. In case of an emergency move switch
the date of purchase by the original consumer. Fellowes warrants all other parts
the date of purchase by the original consumer. If any part is found to be defective
This warranty does not apply in cases of abuse, mishandling, or unauthorized
APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be
This warranty gives you specific legal rights. The duration, terms, and conditions of
this warranty are valid worldwide, except where different limitations, restrictions,
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
andle
Shredder hea
See safety instructions belo
i
asy emptyin
CAPABILITIE
ill shred: Paper, credit cards and staples
not shred: Continuous forms, adhesive labels, transparencies,
ewspaper, cardboard, paper clips, laminates or plastic other than
oted abov
Paper shred size:
ross-Cu
5/32” x 1 3/8” (3.9 x 35mm
IMPORTANT SAFETY INSTRUCTIONS — Read Be
• Keep away from children and pets. Keep hands away
rom paper entry. Always unplug or set safety lock
n not in
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters
top opening, switch to Reverse (R) to back out object.
aximum
Sheets per pass
ards per pass
Paper width
ontinuous operatio
* 20lb., 8.5”x11” paper at 120v, 60 Hz, 4.5Amps; heavier paper,
humidity or other than rated voltage may reduce capacity. Recommended
y usage rates: 10-20 paper passes; 10 cards
ore Using!
Never use aerosol, petroleum based or other flammable
Do not use if damaged or defective. Do not open shredder
11 sheets per pass to avoid jams
Sheets per pass
aper/credit card entr
Safety lock
To set lock, push
own and slide
ontrol switc
uto-On (I
Off (O
everse (R
roducts on or near shredder. Do not use canned ai
n shr
ead. Do not place near or over heat or water source
11*
9”/229mm
minutes
to OFF (O) position. This action will stop shredder immediately.
Continuous operation:
minutes maximum
N
Shredder runs briefly
after each pass to clear entry.
ontinuous operation beyond 5
minutes will trigger 20-minute
cool down period
afety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide towards front of shredder
et to Off (O)
nd plug in
nsert waste bag (Fellowes #36052) for easy disposa
APER
Set to Auto-On (I
AR
et to Auto-On (I
old card
at e
ge
eed into paper entry
releas
an
Feed into center of entr
nd r
et to Off (O)
nd unplu
TROUBLESHOOTIN
Paper jam:
all of the below procedures.
1
et to Reverse
R) for 2-3
et to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or
Alternate slowly back and forth
et to Off (O)
nd unplu
Gently pull uncut paper
rom paper entry. Plug in
et t
Reverse (R
redder doesn’t start
Make sure head is on basket correctl
ait 20 minutes for motor to cool dow
emove and empty basket
ety lock is in unlock position
Make sure sa
MAINTENANC
un regularly in reverse for
one m
nut
ubricate when bin is full, or
mmediately, if:
• Ca
acity decreases
• Motor sounds different, or
redder stops running
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the
Follow oiling procedure below and repeat twice
et to Off (O)
*Apply oi
across entry
Set to Auto-On
R A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE
FITNE
liable for any consequential or incidental damages attributable to this product.
hred one shee
et to Reverse (R
or 2-3 seconds
• Avoid touching exposed blades under Cross-Cut shredder head. • The socket-outlet shall be installed near the equipment and shall be
easily accessible.
replacement, at Fellowes’ option and expense, of the defective part.
repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR