Fellowes DS-1200C, DS-1200CS User Manual

DS-1200Cs

Please read these instructions before use.

Do not discard: keep for future reference.

fellowes.com

A.										F.
										G.
B.
C.										H.

ENGLISH

Model DS-1200Cs

KEY

		A. SafeSense® Technology	E. Pull-out Bin	H. Control Switch and Indicator lights
D.		B. Paper/Card entry	F. Disconnect power switch	R		1. Reverse
		C. Handle	G. See safety instructions	O		2.	OFF
		D. Window			I	3.	Auto-On (green)
						4.	Overheat (red)
E.						5.	SafeSense® indicator (yellow)

CAPABILITIES

Will shred: Paper, credit cards, staples, paper clips and junk mail

Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies, newspaper, cardboard, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:
Cross-Cut...........................................................................	5/32 in. x 2 in. (4mm x 50mm)
Maximum:
Sheets per pass............................................................................................................	12*

Cards per pass...............................................................................................................	1*
Paper entry width.................................................................................	8-6/7 in. (225mm)

*8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 6.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 10-25 paper passes; 10 credit cards. 12 sheets per pass.

Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

ADVANCED PRODUCT FEATURES

Patented SafeSense® Technology

Stops shredder immediately when hands are too close to the paper entry

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

•Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

• Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.

•Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water.

Modifications not approved by the party responsible for compliance could void user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off

•This shredder has a Disconnect Power Switch (F) that must be in the

ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.

•Avoid touching exposed cutting blades under shredder head.

•The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.

and on, the user is encourage to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experience radio/TV technician for help.

1