*20 lb., 8.5”x11” paper at 120v, 60 Hz, 4.5Amps; heavier paper, humidity or other than rated
voltage may reduce capacity.
Fellowes SafeSense® shredders are designed to be operated in home and office environments
ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80%
relative humidity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from
paper entry. Always unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc.–
away from shredder openings. If object enters top opening,
press and hold Reverse (R) to back out object.
• Avoid touching exposed blades under Confetti-Cut shredder head.• The socket-outlet shall be installed near the equipment and shall be
2
• Never use aerosol, petroleum-based or other flammable products on or
near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head.
Do not place near or over heat or water source.
• 11 sheets per pass to avoid jams.
easily accessible.
Page 4
OPERATION
PAPER
Continuous
operation:
5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5 minutes will trigger
20-minute cool down period.
Set to Off
CARD
Press Auto-On ( )
Press Auto-On ( )
Hold credit card
at edge
Feed into paper entry
and release
Set to Off
Feed into card entry
and release
TROUBLESHOOTING
Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.
Press and hold
Reverse (R)
Alternate slowly back and forth
Set to Off Press and hold
Pull uncut paper from
paper entry
Reverse (R)
ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the
SafeSense® feature. (See SafeSense® instructions below.)
Shredder doesn’t start:
Yellow - SafeSense® active
Yellow flashing - SafeSense® not active
Make sure control switch is in Auto-On
( ) position
Clear paper particles covering magnetic
safety interlock
Wait 20 minutes for red light to turn off
SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause
the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the
SafeSense® feature and clear the paper. Warning – when switch is in override position, the SafeSense® light
will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature.
MAINTENANCE
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
Follow oiling procedure below and repeat twice.
Set to OffPress Auto-On ( )
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/
*Apply oil
across entry
WARRANTY
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. Fellowes warrants all other parts of the machine to be free of defects in material and
workmanship for 1 year from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,
Sensor light illuminated–paper
jammed
SafeSense® override switch
ActiveNot active
Shred one sheet
3505006
IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE.
In no event shall Fellowes be liable for any consequential or incidental damages attributable to
this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty
are valid worldwide, except where different limitations, restrictions, or conditions may be required
by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Press and hold
Reverse (R)
2-3 seconds
3
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.