Fatshark FSV2461 User Manual

Model FSV2461 (FCC compliant 5G8 TX, ID# 2ABYQFSV2461)

Model 2461 (FCC compliant 5G8 TX, ID# 2ABYQFSV2461) Spec Doc REV A

Operation:

Power is supplied via the 2p power in connector. 5V is supplied to the camera via the 3p camera connector. When connected to a compatible camera, the camera image is transmitted via the transmitter and antenna. The channels can be selected the 4p DIP switch (see chart). An alternative 5p connector is provided for connecting sources that use the stereo audio channels.

Specifications:

Power supply 6 - 17V (2S-4S supply) Power consumption: 75mA @7.4V (+camera supply) Power out (to camera) 5V, 350mA max Transmitting range: Approximately 200m Operating Frequency: 5G8 (see above frequency chart) Antenna type: fixed circular polarized Dimensions: 39 (+44 antenna) X 26 X 14 mm Weight: 19g (with antenna, no cables)

Connector Function (from left to right)

2p: V+ (6-17V), GND 3p: 5V, GND, VID 5p: 5V, GND, VID, AUDL, AUDR

Packaging

Dimensions: 120 x 40 x 18 mm Weight: 40g

Note: 5p connector is for connecting cameras with audio or ImmersionRC TinyTelemetry accessory (adds Telemetry data to audio channel so plane can be tracked with the ImmersionRC antenna tracker for longer range)

www.fatshark.com

1. This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the

party responsible for compliance could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

ϋϋ Reorient or relocate the receiving antenna.

ϋϋ Increase the separation between the equipment and

receiver.

ϋϋ Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

ϋϋ Consult the dealer or an experienced radio/TV technician

for help.