Fantasea F Series RedEye Filter User Manual

Important Notice

This instruction manual relates to the EyeDaptor FP7000-F67, RedEye Filter
FP7000 and PinkEye Filter FP7000. Please refer to corresponding paragraphs

below for relevant instructions.

EyeDaptor FP7000-F67

RedEye Filter FP7000

PinkEye Filter FP7000

67mm Add-On Plate

EyeDaptor FP7000

EyeDaptor FP7000

EyeDaptor FP7000

RedEye Insert

PinkEye Insert

6 x Screws

Secure Line

Secure Line

Screwdriver

Snap Cord

Snap Cord

Secure Line

EyeDaptor FP7000

67mm Add-On Plate

PinkEye/RedEye Inserts

1. Introduction

 EyeDaptor FP7000-F67 (Cat. No. 4702) – Enables mounting 67mm threaded accessory lenses and filters

on the FP7000 Housing. Specially designed to allow mounting the SharpEye Macro Lens M67 (Cat. No.

5128) on the FP7000 Housing lens port.

 RedEye Filter FP7000 (Cat. No. 5211) – Red color correction filter for the FP7000 Housing. Used to

restore the red color absorbed by blue water and allows for producing vivid and colorful underwater
images and videos.

 PinkEye Filter FP7000 (Cat. No. 5212) - Pink (magenta) color correction filter for the FP7000 Housing.

Used to restore the pink color absorbed by green water and allows for producing vivid and colorful
underwater images and videos.

Fantasea FP7000 Adaptors & Filters

(Cat. No. 4702, 5211, 5212)

Instruction Manual

2. Included in Packaging

3. Identification of Parts

1

FP7000 Adaptors & Filters Instruction Manual 20110524

Important Notice

Please use the utmost care and do not use excessive force when assembling and
disassembling the different accessories, in order to not cause any damage to the
product.

Image #1

Image #2

Image #3

Image #4

4. Instructions for Use

1. Assembling the EyeDaptor FP7000-F67
a. Place the 67mm Add-On Plate on a flat and protected surface, so that the thread is facing down and

the concaved side of the plate is facing up (image #1).

b. Place the EyeDaptor FP7000 over the 67mm Add-On Plate so that the adaptor configuration is facing

up and the flat side of the adaptor is facing the 67mm Add-On Plate (image #2).

c. Gently turn the EyeDaptor FP7000 around, till the screw holes on the EyeDaptor FP7000 are aligned

with the screw holes on the 67mm Add-On Plate.

d. Insert the 6 screws included into the aligned screw holes of the EyeDaptor FP7000 and 67mm Add-

On Plate. Use the screwdriver included in order to tighten the screws (image #3). Tighten the screws
enough in order to keep them from falling out, but don’t tighten them too strongly, as this might
cause damage to the products.

e. Once the EyeDaptor FP7000-F67 is assembled, lens accessories featuring a 67mm male thread can

be mounted on the adaptor by gently screwing them into the female thread (image #4).

2

FP7000 Adaptors & Filters Instruction Manual 20110524