Fanimation B1870436 User Manual

INSTALLATION INSTRUCTIONS

Model Series
BP200**1

BP230**1

READ AND SAVE THESE INSTRUCTIONS

AIRE DÉCOR

Ceiling Fan

1

2. PACKAGE CONTENTS

Philips screw driver
Blade screw driver
11 mm wrench
Step ladder
Wire cutters

1. TOOLS AND MATERIALS
REQUIRED

Unpack your fan and check the contents. You
should have the following items:

a. Blade set (5)
b. Hanger bracket
c. Canopy
d. Downrod
e. Fan motor assembly
f. Blade bracket set (5)
g. Light kit (Optional)
h. Glass shades (3) (Optional)
i. Package hardware

1) wire nuts (4)

2) Blade attachment hardware:

screws (16), fiber or rubber washers (16)

3) Pull chain and fobs

4) Blade holder attachment hardware:
screws (11)

5) Balance Kit

a

b

c

d

e

f

g

h

i

1. To reduce the risk of electric shock, insure
electricity has been turned off at the circuit
breaker or fuse box before beginning.

2. All wiring must be in accordance with the
National Electrical Code and local electrical
codes. Electrical installation should be
performed by a qualified licensed electrician.

3. WARNING: To reduce the risk of electrical
shock and fire, do not use this fan with any
solid-state fan speed control device.

4. WARNING: To reduce the risk of personal
injury, use only the two steel screws (and lock
washers) provided with the outlet box for
mounting to the outlet box. Most outlet boxes
commonly used for the support of lighting
fixtures are not acceptable for fan support and
may need to be replaced, consult a qualified
electrician if in doubt.

5. The outlet box and support structure must be
securely mounted and capable of reliably
supporting a minimum of 50 pounds. Use only
UL Listed outlet boxes marked "FOR FAN
SUPPORT".

6. The fan must be mounted with a minimum of 7
feet clearance from the trailing edge of the
blades to the floor.

7. Do not operate reversing switch while fan
blades are in motion. Fan must be turned off
and blades stopped before reversing blade
direction.

8. Avoid placing objects in the path of the blades.

9. To avoid personal injury or damage to the fan
and other items, be cautious when working
around or cleaning the fan.

10. Do not use water or detergents

when cleaning
the fan or fan blades. A dry dust cloth or
lightly dampened cloth will be suitable for most
cleaning.

11. After marking electrical connections, spliced
conductors should be turned upward and
pushed carefully up into outlet box. The wires
should be spread apart with the grounded
conductor and the equipment-grounding
conductor on one side of the outlet box.

12. Electrical diagrams are reference only. Light kit
that are not packed with the fan must be UL
Listed and marked suitable for use with the
model fan you are installing. Switches must be
UL General Use Switches. Refer to the
Instructions packaged with the light kits and
switches for proper assembly.

2

3. SAFETY RULES

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK OR PERSONAL INJURY, MOUNT

FAN TO OUTLET BOX MARKED

"ACCEPTABLE FOR FAN SUPPORT".

WARNING

TO REDUCE THE RISK OF PERSONAL

INJURY, DO NOT BEND THE BLADE

BRACKETS (ALSO REFERRED TO AS

FLANGES) DURING ASSEMBLY OR AFTER

INSTALLATION. DO NOT INSERT OBJECTS IN

THE PATH OF THE BLADES.