Falcon Predator EVO4 V2, Predator EVO4+2 Installation Manual

1

FALCON

WOR LD CLASS SE CUR ITY

FALCON PREDATOR EVO4 V2

Vehicle Security System with Remote Starter

Installation Manual

Table of Contents:

A) Introduction..............................................................................................................2

A-1) Features......................................................................................................2

A-2) Key Function Table........................................................................................2

B) Optional Programming Features...................................................................................3

C-1) Programming Option Table.............................................................................3

B-2) Explanation of Programming Options ...............................................................4

C) Remote Transmitter Code Learning ..............................................................................7

D) Installation Notes ......................................................................................................7

D-1) Ignition 2 Connection....................................................................................7

D-2) Installation without Remote Starter Features....................................................7

E) Suggested Location of Installing the Antenna.................................................................8

F) Wiring Diagram..........................................................................................................9

G) Wiring Note #1 .......................................................................................................10

H) Wiring Note #2 .......................................................................................................11

HELPLINE: 0906 700 10 20

(All calls charged at 50p/min)

Falcon Security Ltd. Unit 9 Tanning Court, Warrington, Cheshire, WA1 2HF, UK

Internet: http://www.falcon-security.com Email: [e-mail]

2

A) Introduction

The Falcon Predator EVO4 is a unique Vehicle Security System with Remote Engine Starter
System and is designed to provide the highest level of security and convenience.

The Falcon Predator EVO4 has many programmable functions so please read this manual
carefully before installing the Falcon Predator EVO4 system.

A-1) Features

• 2 x Four Button Remote Controls

• Code Hopping and Code Learning

Remote System

• Up to 4 remote transmitters
Programmable

• Remote Engine Start with system
armed/disarmed

• Timer Engine Start

• Turbo Timer

• Remote Arm/Disarm

• Mute Arm/Disarm

• Immobiliser

• Remote Boot Release

• Passive or Active Lock Programmable

• Auto Re-arm

• Ignition Lock/Unlock

• Car Finder

• Audible Intrusion Zone Identification

• Defective Zone Alert and Bypass

• Keyless Entry While Ignition is on

• Remote Panic Alarm

• Anti-Hijacking

• Emergency System Override

• Remote Valet Mode

• Passive Arming

• Siren programmable for 30 or 60

seconds

• Built in Central Locking Control

• Built in Total Closure Control

• Central Lock Active Time selectable 0.5

or 3.5 seconds

• Plug-In Dual Stage Shock Sensor

• Shock Sensor Bypass

• Interior Light Delay Time

programmable

A-2) Key Function Table

Button Armed Disarmed Ignition On

Button 1 once Arm Arm
Button 2 once Disarm Disarm
Button 1 for 3 secs Panic Panic Panic
Buttons 1+3 for 1 sec Channel 3 Channel 3 Channel 3
Button 3 once Car Finder Car Finder Anti-Hijacking
Button 3 for 2 secs Boot Release Boot Release RPM Learning
Button 4 for 3 secs Remote Start On/Off Remote Start On/Off
Buttons 1+2 once Mute Disarm Mute Arm Valet Mode
Buttons 1+4 for 1 sec Timer Start On/Off Timer Start On/Off

3

B) Optional Programming Features

The Predator EVO4 has additional features for different types of vehicles.
Read the below programming functions carefully to have the right options programmed for your
vehicle and your needs.

a> Under the system disarm mode, keep the door open, and switch the ignition on-off, on-off,
on-off and then back to On.

b> Siren will chirp for 2 seconds to confirm entering the programming option mode.
c> To choose the function #1 – 23: Within 20 seconds after taking step b Press button 1 the

same number of times as the function # you wish to program. Each time you press button 1, a
single short chirp will follow. For example, if you want to choose #11 Start Mode Select, press
button 1 eleven times.
Pressing Button 4 for 3 seconds will the programming options will be reset to factory default, the
siren will chirp for 2 seconds to confirm and the system will leave programming mode.

d> To confirm the selected mode, Press button 2. Siren will chirp as many times as you pressed
button 1 in step C to confirm the function you chose. For example, if you press button 1 eleven
times in step C, 11 single short chirps will follow.

e> Now you can program the features and settings by pressing buttons 1, 2 or 3.
When you press button 1, a single chirp will sound, for Button 2 two chirps and button 3 three

chirps to indicate the selected setting has been programmed.
The system will leave the programming mode if there is no action made with in 20 seconds your

previous action or the ignition is turned off. The siren will sound for 2 seconds to conf irm the
system has left programming mode.

C-1) Programming Option Table

No. Function

BTN (1)

Chirp Once

BTN (2)

2 Chirps

BTN (3)

3 Chirps

01 Chirp Confirmation On/Off On Off
02 Shock Sensor Bypass Disabled First Both
03 Passive Arming Disabled Enabled
04 Passive Locking Disabled Enabled
05 Ignition Locking Disabled Enabled Lock Only
06 Door Lock Time 1 Pulse 2 Pulses 4 Sec.
07 Siren/Horn Siren Horn

08 Alarm Condition/Cycle Duration 30 Secs 60 Secs
09 Interior Light Delay Disables 15 Secs
10 Auto Rearm Disabled Enabled
11 Anti-Hijacking Delay 15 Secs 60 Secs
12 Anti-Hijacking by Remote Control Disabled Enabled
13 Anti-Hijacking by Door Opening Disabled Enabled
14 Turbo Timer Disabled 120 Secs 180 Secs

15 Car Type Automatic Manual
16 Remote Start Conditions Arm Normal
17 Door Lock/Unlock with Remote Start Disabled Enabled
18 Remote Start Mode Alternator TACH
19 Crank Time 600ms 800ms 1000ms
20 Engine Running Time 10 Min 20 Min
21 Timer Start 3 Hours 6 Hours 12 Hours
22 Alternator Voltage 4.5V 9.0V
23 Channel 3 Output Disable Enable

*Note: The factory defaults are pre-programmed as per the first column (grey box).

4

B-2) Explanation of Programming Options

01) Chirp confirmation on/off: Factory default = On
The siren will chirp once to enter armed mode and twice to enter disarmed mode when
programmed as on. The siren will not chirp if programmed as off.

02) Shock Sensor Bypass: Factory default = Disabled
When programmed as Disabled: The shock sensor will work normally
When programmed as First: The 1

st

stage shock sensor will be bypass after 3 continual triggers

When programmed as Both: Both stages of the shock sensor will be bypassed after 3 continual
triggers.

03) Passive Arming: Factory default = Disable
When programmed as Disabled: The feature will not be activated

When programmed as Enabled: The LED will flash rapidly and system will enter the armed
mode automatically after 30 seconds of turning the ignition off and closing the last opened door,
the bonnet and boot. The siren will chirp and parking lights flash once to confirm and the
immobiliser turns on.

04) Passive Locking: Factory default = Disabled
When programmed as Disabled: The doors will not be locked when the passive arming feature is
activated.

When programmed as Enabled: The doors will be locked when the passive arming feature is
activated.

05) Ignition lock: Factory default = Disabled
When programmed as Disabled: The doors will not be locked when turning the ignition on and
will not be unlocked when the ignition is off

When programmed as Enabled: The doors will be automatically locked 15 seconds after the
ignition is turned on and the doors will be unlocked immediately upon the
ignition being turned off

When programmed as Lock Only: The doors will be locked 15 seconds after turning the ignition
on but will not be unlocked after turning the ignition off.

06) Door lock time: Factory default = 1 Pulse
When programmed as 1 Pulse: The system will send one 1 second pulse when locking or
unlocking the doors.

When programmed as 2 Pulse: The system will send one 1 second pulse when locking the doors
and two 1 second pulses when unlocking the doors.

When programmed as 4 sec.: The system will send one 4 second pulse when locking or
unlocking the door.

07) Siren/Horn: Factory default = Siren
When programmed as Siren: The system will send a constant output
When programmed as Horn: The system will send an intermittent output with a 0.5 second
interval between each output. An extra relay should be added if Horn is selected.

08) Alarm condition cycle duration: Factory default = 30 seconds.
To program the alarm time as 30 or 60 seconds.

09) Interior light delay: Factory default = Disabled
If the vehicle has a delay on turning off the interior light when closing the door, set the Interior
Light Delay to 15 or 40 Secs.