Factory Direct Hardware 27831 User Manual

Installation Instructions / Warranty

Citterio

27831XXX

Terrano

27834XXX

Carlton

Phoenix

27835XXX

Axor Citterio Wallbar Set

27831XXX

Axor Terrano Wallbar Set

27834XXX

Axor Carlton / Phoenix Wallbar Set

27835XXX

27831XXX 27834XXX 27835XXX

This wallbar set contains the wallbar and a 63” Techniflex handshower hose. It is compatible with
any Hansgrohe handshower.

2

Axor Citterio Wallbar Installation

Mark the positions for the screw holes (1). The center
of the top hole should be 36” from the center of the
bottom hole.

Drill the holes with a 6 mm bit suitable for the wall
surface (2).

Install the anchors. Seal the wall around the anchors
with waterproof sealant.

Install the mounting pieces with the screws and metal
washers.

Place the wallbar over the mounting pieces (1).
Tighten the set screws with a 3 mm Allen wrench (2).

3

Axor Terrano / Carlton / Phoenix Wallbar Installation

Mark the positions of the screw holes, using the holes on
the mounting pieces as a template. When positioning the
support element on the wall, make sure that the notch is at
the bottom.

Put the support elements in a safe place. Drill the holes
using a 6mm bit suitable for the wall surface.

4