Factory Direct Hardware 2035 User Manual

1-800-526-2400

®

INSTALLATION INSTRUCTIONS

1.

Hand of door and closer must be the same.
RH or LH will be stamped on mounting plate.
See proper template for your application.

Attach arm to closer, as shown above. The bend

2.

in arm will always point towards door.

2030 SERIES

Track mortise in top of door must match proper template.

5.

Place roller in track as shown. Mount track in door with holes
for hold open clip toward hinge edge. Fasten with screws
provided.

Open door to approximately 45°. Pull arm over top of door.

6.

Align hole in end of arm with roller stud. Fit closer arm
completely onto roller stud and tighten arm set screw securely.

Adjust only if more power is needed. Closer

7. closing power

is shipped with minimum closing power pre-set. To increase
closing power turn spring adjusting screw clockwise. Maximum
adjustment 36 turns.

15 ft-lbs

=

21 N-m

MAXIMUM
OPENING TORQUE

3.

Install closer including arm in prepped frame with
mounting screws provided. Be sure mounting plate
is flush with soffit.

APPLIED
STOP BY
OTHERS

4.

After closer is mounted in door jamb, attach applied

stop to head frame, as shown above. Stop section

must have access hole to allow for door closer

adjustment.

! - DO NOT USE ABRUPT BACKCHECK- NOR

EXPECT DOOR CLOSER TO ACT AS A DOOR STOP!

8. The 2030 series closer has been regulated prior to
shipment. If adjustments are necessary, carefully follow
instructions. DO NOT REMOVE COVER PLATE TO MAKE
ADJUSTMENTS.

CLOSING SPEED:

Regulating screw locations are shown in illustration at left and
also on door closer label. To adjust Main Speed, turn
regulating screw clockwise to decrease or counter-clockwise
to increase. To adjust Latch Speed, turn regulating screw
clockwise to decrease or counter-clockwise to increase.

BACKCHECK:

speed of doors. Use enough backcheck to sufficiently slow the
doors opening speed. To increase resistance, turn
regulating screw clockwise.

See Closer Control Diagram below.

This control hydraulically dampens the opening

BACKCHECK

MAIN SPEED

LATCH
SPEED

HOLD OPEN INFORMATION

To install and adjust hold open option, see Fig. 1 and
follow these directions: Tip hold open clip into track.
Locate at desired hold open position and fasten with
screw . Tip cam into track & locate as shown. fasten

3

with screw . Push door into hold open position and check
for proper operation. To holding power, loosen
screw and slide cam toward latch edge of door. To
holding power, slide cam toward hinge edge. Re-tighten screw .

09/06 ©2006 SCHLAGE LOCK Company. All rights reserved. DP# 18758R6

1

increase

1 decrease

1

CAUTION

!

IMPROPER INSTALLATION OR
REGULATION MAY RESULT IN

PERSONAL INJURY OR

PROPERTY DAMAGE. FOLLOW ALL

INSTRUCTIONS CAREFULLY. FOR

QUESTIONS, CALL LCN AT

800 - 526 - 2400

®