Installation Instructions / Warranty
Massaud
18440001
2
Axor Massaud Trim, 4-Hole Roman Tub Set
18440001
check valve
Product Specification
Max. incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Max. incoming hot water temp. 176oF*
Recommended hot water temp. 120oF - 140oF*
Max. flow rate at 44 psi approx. 4.5 gpm
Max. flow rate of handshower 2.5 gpm
*Know and follow all applicable local plumbing
codes when setting the temperature on the water
heater. In Massachusetts, the water heater may be
set no higher than 112oF.
Installation Considerations:
This trim kit is for use with rough valve 13444181. The rough must be installed and the mounting
surface complete and sealed before installation of this trim kit.
Protection against back siphonage provided by check valve.
Installation
Turn the water off at the main (1).
Remove the plaster shields from the hot and cold valves
and the diverter housing (2).
Install the escutcheons (1).
Install the color rings (2). Push the handles firmly over the
escutcheons and color rings. Turn the handles clockwise
so that the valves are in the off position (3).
Remove the plug from the diverter housing (1). Install the
spout escutcheon (2).
Put a light coating of the enclosed lubricant on the
diverter o-rings (3). Press the diverter firmly into the housing (4).
3.
2.
1.
1.
4.
2.
3.
3
4
Push the spout firmly over the diverter (1). Install the
diverter pull rod (2).
2.
1.
Tighten the spout set screw with the enclosed 3 mm
Allen wrench (1).
Pull upward on the plaster shield, exposing the
Secuflex hose (2).
Spray the end of the Secuflex hose with silicon lubricant
(included). This will make it easier to remove from the
holder.
2.
1.
Pull the Secuflex hose completely out of the holder, to
expose the high pressure hose. Separate the Secuflex
hose from the high pressure hose by unscrewing the
nut (1).
Remove the plug (2) from the high pressure hose.
Install the check valve (3). The arrow should point in
the direction of the water flow. Attach the handshower hose to the high pressure hose (4).
Lubricate the handshower hose and the ends of the Secuflex hose with the silicon lubricant.
Push the handshower hose up through the Secuflex hose
(1). Push the end of the Secuflex hose over the high
pressure hose and tighten the nut (2). Remove the plaster
shield (3).
5
6
Unscrew the nut from the handshower holder. Remove
the insert.
Compress the Secuflex hose so that the end of the
handshower hose can be grasped.
Push the handshower hose through the handshower
holder (1). Snap the two halves of the insert around the
hose (2). Push the nut over the end of the hose (3) and
screw it back into place (4).
Push the handshower holder escutcheon over the hose
and handshower holder (1).
Place the handshower screen washer into the hose end
connector on the handshower hose. Install the handshower (2).
1.
2.
Cut the o-rings on the end of the Secuflex hose.
Push the handshower holder down into the Secuflex
holder. The pin on the Secuflex holder should engage the
hole in the bottom of the handshower holder.
Secure the handshower holder by turning the escutcheon clockwise, so that it threads down onto the Secuflex
holder.
Place the handshower in the holder.
If the handshower becomes hard to pull out, spray a cloth
with some of the silicon lubricant and wipe the handshower hose.
If the flow of water from the handshower diminishes over
time, remove and clean the screen washer.
7
8
Scale Removal
The handshower incorporates the RubitTM self cleaning
system. If scale deposits are noticed in the spray channels, turn the water on lightly and rub across the channels
with a finger or a sponge to dislodge them.
If scale deposits are noticed on the spray face, pour
about 3/4” of a commercial scale remover, such as
Lime-Away or CLR (diluted if directed) into a shallow dish.
Soak just the spray face of the handshower in the cleaner.
Rinse the handshower with clear water.
Reinstall the handshower and flush thoroughly with clear
water.
Replacement Parts
3
1
6
7
4
5
12
1 diverter knob 98707000
2 spray former 97448000
3 spout 98706000
4 handle escutcheon 98708000
5 diverter 96775000
6 handle 18098000
7 spout escutcheon 97779000
8 handshower holder escutcheon 94052000
9 screen washer 94246000
10 handshower 28509001
11 handshower holder 92380000
12 hose 94148000
13 check valve 94074000
2
9
8
11
13
10
9
10
Cleaning Recommendation for Hansgrohe Products
Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with
regard to design and functionality.
To avoid damage and returns, it is necessary to consider certain points when cleaning:
Cleaning materials for faucets and shower products:
Acids are necessary ingredients of cleaning materials for removing lime. However, please pay attention to the following points
when cleaning faucets and shower products:
• Use only cleaning materials intended for the application.
• Never use cleaning materials which contain hydrochloric, formic, or phosphoric, or acetic acid, as these can cause
considerable damage.
• Do not mix one cleaning material with another.
• Do not use abrasives, such as cleaning powders, sponge pads, or microfiber cloths.
Cleaning Instructions for Faucets and Shower Products:
Please follow the cleaning material manufacturer’s instructions. In addition, please note the following:
• Clean your faucets and shower products as and when required.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
• Regular cleaning will prevent scale buildup and water spotting.
• When using spray cleaners, spray first onto a sponge or cloth. Do not spray directly onto the faucet or shower product
as drops could enter openings or gaps and cause damage.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note:
• If the surface is already damaged, the effect of cleaning materials will cause further damage.
• Components with damaged surfaces must be replaced, otherwise, this could cause injury.
• Damage caused by improper treatment will not be covered by our warranty.
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to
Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or
Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship
as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product that proves defective
because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a
replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of
the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a
consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you
own the product and the home in which the product is originally installed. If you purchased the product for use primarily for any other purpose,
including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products,
and (ii) for 5 years, with respect to AXOR products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper maintenance, misuse, abuse,
negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no-rinse” cleaning products, or the use of the
product in any manner contrary to the product instructions. (3) Conditions in the home such as excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for installation or reinstallation
of the product (including but not limited to proper packaging and shipping costs), or for installation or reinstallation of the product.
D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your Hansgrohe retailer, or contact Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Toll-free (800) 334-0455.
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass Lakes
Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS
THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY
OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES,
ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights, and you may have other rights which vary from State to State. You may be required by law to
give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the MagnusonMoss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing, always
carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions at any time
about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us or call us toll-free at 800 334
0455.
11
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004
Tel. 770 360-9880 • Fax 770 360 9887
www.hansgrohe-USA.com
US - Installation Instructions • Part No. 90414521 • Revised 04/2007
Loading...