Factory Direct Hardware 18115001 User Manual

Page 1
Installation Instructions / Warranty
Massaud
18112001
Massaud
18115001
Page 2
2
Axor Massaud 3-Hole Lavatory Mixer Trim with Short Spout 18112001 Axor Massaud 3-Hole Lavatory Mixer Trim with Long Spout 18115001
18112001
Product Specification
Max. Flow Rate 2.2 gpm Max. incoming water pressure 145 psi Recommended water pressure 14.5 - 72 psi Max. hot water temperature 176o F* Recommended hot water temp 120oF - 140oF* No drain is included. Requires rough valve 18113181 (not included).
Do not place more than 8 lbs on the spout. Please note that prolonged exposure to residues from soap, shampoo, toiletries, or cosmetics can damage the finish. Such damage is not covered by the Hansgrohe warranty.
This unit can be used with continuous flow water heaters if the flow pressure is at least 20 psi.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no higher than 112oF.
Page 3
Installation
Remove the caps from the plaster shields on the rough valve (1). Cut the plaster shields so that they extend 1/16” outside the surface of the finished wall (2). Seal the wall around the plaster shields with waterproof seal­ant.
Remove the plug from the spout outlet using a 17 mm socket wrench (1).
Install the slip coupling on one of the the valves (2). Mark a point on the slip coupling 3/16” from the surface of the finished wall. Cut the slip coupling at that point (3). Repeat with the second slip coupling.
Install the spindle extension on one of the valves (1). Mark a point on the spindle extension 9/16” from the sur­face of the finished wall. Cut the spindle extension at that point (2). Repeat with the second spindle extension.
3
1
2
3
Page 4
4
Insert a measuring device in the spout outlet. Measure from the port on the rough to the end of the plaster shield. Record this measurement (X). Add 2” to X. Cut the spout connector so that it is X + 2” long.
Wrap the threads on the spout connector with Teflon thread tape (1). Screw the spout connector into the spout port using a 12 mm Allen wrench (not included) (2). The spout connector should extend 1 3/16” outside the surface of the finished wall.
Install the handle sealing rings, escutcheons, nuts, snap connectors and screws, and color rings (3). The blue color ring should be on the right, the red color ring on the left.
1
2
3
Page 5
Make sure that the snap connectors are firmly screwed to the nuts. Place the handles over the snap connectors and press very firmly into place.
Position the spout adapter and seal over the spout con­nector. Secure the adapter to the rough with the screws.
Slide the spout into place over the adapter and con­nector(1). Tighten the top set screw with a 3 mm Allen wrench (included) (2). Tighten the bottom set screw (3).
2
1
3
5
Page 6
6
Replacement Parts
18112001
8
11
12
6
5
4
2
10
1
3
1 handle 18098000 2 color ring set 98698000 3 snap connector 94184000 4 nut 98677000 5 handle escutcheon 98697000 6 fixing set 96392000 7 spout 98700000 8 spout 98658000 9 spray former 97448000 10 spray former 97446000 11 spout connector 97228000 12 16 x 2.5 o-ring 98134000
Page 7
18115001
7
9
11
12
1
3
6
5
4
2
7
Page 8
8
Cleaning Recommendation for Hansgrohe Products
Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality.
To avoid damage and returns, it is necessary to consider certain points when cleaning:
Cleaning materials for faucets and shower products:
Acids are necessary ingredients of cleaning materials for removing lime. However, please pay attention to the following points when cleaning faucets and shower products:
Use only cleaning materials intended for the application.
Never use cleaning materials which contain hydrochloric, formic, or phosphoric, or acetic acid, as these can cause
considerable damage.
Do not mix one cleaning material with another.
Do not use abrasives, such as cleaning powders, sponge pads, or microfiber cloths.
Cleaning Instructions for Faucets and Shower Products:
Please follow the cleaning material manufacturer’s instructions. In addition, please note the following:
Clean your faucets and shower products as and when required.
Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
Regular cleaning will prevent scale buildup and water spotting.
When using spray cleaners, spray first onto a sponge or cloth. Do not spray directly onto the faucet or shower product
as drops could enter openings or gaps and cause damage.
After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note:
If the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced, otherwise, this could cause injury.
Damage caused by improper treatment will not be covered by our warranty.
Page 9
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product that proves defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you own the product and the home in which the product is originally installed. If you purchased the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, and (ii) for 5 years, with respect to AXOR products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper
maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no-rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. (3) Conditions in the home such as excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for
installation or reinstallation of the product (including but not limited to proper packaging and shipping costs), or for installation or reinstallation of the product.
D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your Hansgrohe retailer, or contact Technical Service at:
Hansgrohe Inc. 1492 Bluegrass Lakes Parkway Alpharetta GA 30004 Toll-free (800) 334-0455.
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
9
Page 10
10
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from State to State. You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions at any time about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us or call us toll-free at 800 334 0455.
Page 11
11
Page 12
Hansgrohe, Inc. 1490 Bluegrass Lakes Parkway Alpharetta, GA 30004
Tel. 770 360-9880 Fax 770 360 9887
www.hansgrohe-USA.com
US - Installation Instructions Part No. 90414221 Revised 12/2006
Loading...