Factory Direct Hardware 18020001 User Manual
Installation Instructions / Warranty
Massaud
18020001
2
Axor Massaud Single-Control Highriser Lavatory Faucet
18020XX1
Product Specification
Max. Flow Rate 2.2 gpm
Max. incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Max. hot water temperature 176o F*
Recommended hot water temp 120oF - 140oF*
Hole size in mounting surface 1 3/8”
Max. mounting surface thickness 1 5/8”
10 mm supply hoses -- 10 mm - 3/8” adapters included.
No drain or pull rod is included.
This faucet may be used with a continuous flow water heater
if the flow pressure is at least 20 psi.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no
higher than 112oF.
Do not allow the supply hoses to bend
or twist!
Installation
Position the faucet and sealing ring on the mounting
surface.
From beneath the mounting surface, install the fiber
washer, metal washer, and mounting nut. Tighten the
tensioning screws.
Install the adapters on the stops. Install the filters on the
adapters.
Slide the compression nut, cone washer, metal washer,
and rubber washer over the end of the supply hose.
Place the supply hose in the filter.
3
Loading...