Factory Direct Hardware 17010 User Manual

Installation Instructions / Warranty

Axor Carlton

17010XX1

2

Axor Carlton Single Control Lavatory Faucet
17010XX1

Technical Specification

Hole size in mounting surface
Minimum 1-3/8” Maximum 1-5/8”
Maximum mounting surface depth 1-1/4”
Flow rate 2.2 GPM
Maximum operating pressure 145 PSI
Recommended operating pressure 22 - 72.5 PSI
Recommended hot water temp 120o - 140o F*
M3 cartridge with BolticTM handle screw

*Some governing bodies require that the water heater be set to 120o F or
less. Please know and follow all local codes when setting the temperature
on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends installation by a licensed professional plumber.

• Large differences in pressure between the hot and cold supplies should be balanced.

• The supply hoses on this faucet require supply stops with 3/8” compression fittings (not included).

• This faucet has a high temperature limit stop. It ships from the factory on the maximum setting, but may

be reset to a lower temperature if desired.

Install the faucet

Place the faucet and sealing ring on top of the
mounting surface.

Install the mounting flange over the stud. Thread
the collar onto the stud until the mounting flange is
firmly against the bottom of the mounting surface.

Secure the supply lines to the stop valves with
the

3/8”

compression fittings (not included).

Use two wrenches to insure that supply hoses
do not twist.

stud

sealing ring

mounting
flange

collar

For proper operation of the faucet, hot
should be on the left, and cold should be on
the right.

Install the drain.

Re-set the high temperature limit stop (if desired). Install the handle.

Turn on the water and check for leaks at all connections.

3