Factory Direct Hardware 16884 User Manual

Hansgrohe Internet Dealer www.NeedPlumbingSupplies.com 800-728-8890

27454 Wall Outlet
Installation

This unit requires a 1/2” male threaded pipe fitting extending 3/4” outside
the surface of the finished wall.

Wrap the pipe fitting with two layers of TeflonTM thread tape. Seal the wall
around the pipe fitting with silicone.

Install the female end of the elbow through the gasket and onto the fitting.
Test for leaks.

Install the cover over the elbow and snap into place on the gasket.
Install the handshower hose.

Care Instructions

Regular cleaning with a mild soap/water solution and a soft cloth will
keep your finish looking new . Rinse thoroughly with clear water and polish
dry with a soft cloth.

Do not use cleaners containing solvents, acids, or abrasives.

Backflow Prevention

This wall outlet does not include a backflow prevention
device, which is required by code in many areas. W e recommend the use

of Hansgrohe model 06510 vacuum breaker or a comparable device. The
Hansgrohe 06510 vacuum breaker should be installed between the hose
and the wall outlet, NOT between the handshower and the hose.

Hansgrohe Faucets & More www.NeedPlumbingSupplies.com 800-728-8890