Installation Instructions / Warranty
Starck
Tub Filler
10402XX1
90573601-00 7/2005
Starck Tub Filler
10402XX1
T echnical Specification
Maximum incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Recommended max. incoming hot water temp. 120oF - 140oF*
Flow rate of tub filler @ 45 psi 5.75 gpm
Flow rate of handshower 2.5 gpm
Backflow prevention furnished by check valve in the handspray outlet and automatically
closing diverter
Installation Considerations
• This unit requires 2 1/2" female fittings, located 5 7/8" apart on center
recessed 3/8" behind the surface of the finished wall.
• This unit is not anti-scald. If anti-scald is required by local plumbing code, or is
desired, install this unit with a remote pressure balance valve, such as Hansgrohe
13418181 or similar unit.
2
(+/- 5/8"),
Installation
• Flush the supply lines for at least 5 minutes before installing the tub filler. Damage
to the cartridge caused by debris is not covered under the Hansgrohe warranty.
• Wrap the threads on the S-connectors
with Teflon® thread tape. Screw the Sconnectors into the female fittings and
align them so that they are level and are
5 7/8" apart on center. The end of the
S-connector should extend 1 3/8”
outside the surface of the finished
wall.Seal the wall around the
connectors with a waterproof bathroom
sealant suitable for the wall surface.
• Position the mixer over the S-connectors.
Rotate the flanges clockwise to screw
them firmly to the S-connectors.
1 3/8”
• Place the black rubber hose washer in the shorter of the two handshower hose
ends. Screw this end to the handshower outlet on the bottom of the mixer. Place
the screen washer in the longer hose end and attach it to the handshower. Place
the handshower in the holder on the side of the mixer.
• Turn on the water and check all connections for leaks.
3
User Instructions
• Pivot the lever upward to turn the water on, down to turn it off. Pivot the handle left
to obtain warmer water, to the right to obtain cooler water.
• When the unit is turned on, the water will come from the tub filler. Pull the diverter
knob to obtain water from the handshower When the water is turned off, the
diverter will automatically reset to the tub filler position.
• The handshower uses the Rubit!™ self-cleaning system. The
spray channels are lined with a material that resists scale
buildup. If scale buildup is noticed in the spray channels, turn
the water on lightly and rub across the channels with a finger
or a sponge to dislodge them.
• The check valve located in the handshower outlet should be
removed and checked yearly.
Reset the High Temperature
Limit Stop (Optional)
• Use a 4 mm allen wrench to push the
gray rubber screw cover through the
hole in the handle. Loosen the handle
screw 4 complete turns. Pull the
handle off. Retrieve the screw cover.
• Remove the nut cover and the handle
screw.
• Center the cartridge stem.
4
• Remove the handle screw. Pull the
green high temperature limit stop
straight off the cartridge.
• Reinstall the high temperature limit stop
so that the positioning pin on the
cartridge is in the hole for the desired
high temperature. The temperatures
shown on the diagram assume an
incoming cold water temperature of
o
50
F and an incoming hot water
temperature of 140oF.
• Test the unit. Reposition the high
temperature limit stop again if required.
• Reinstall the nut cover. Reinstall the
handle screw and tighten four complete
turns. Reinstall the handle and continue
tightening the screw. Reinstall the screw
cover.
1
Replacement Parts
1 Handle 10490XXX
1.1 Screw cover 96338000
2 Flange 96395000
3 Nut 96461000
4 Cartridge 92730000
5 Flange 96467000
6 S-connector
7 Diverter 94077000
8 Diverter knob 96466XXX
9 Check valve 94074000
10 noise reducer 96429000
11 hose 28282XXX
12 screen washer
13 handshower 28531XXX
14 spray former 97467000
XXX = color
000 = chrome
2
3
4
6
5
10
1.1
13
8
12
14
7
9
11
5
Cleaning Recommendation for Hansgrohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the
market with regard to design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper
treatment is not covered under the Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale, use only products made specifically for that purpose. Always follow the
manufacturer’s instructions when using.
• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause
considerable damage to finishes and to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale
buildup and water spotting.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than
necessary.
• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after
use.
• If the surface is already damaged, harsh cleaning materials will cause further damage.
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to
Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or
Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship
as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product which proves defective
because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to
provide a replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for
the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a
consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you
own the product and the home in which the product is installed. If you purchased the product for use primarily for any other purpose,
including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products,
and (ii) for 5 years, with respect to AXOR, ShowerPower and Pharo products.
6
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident
or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any
manner contrary to the product instructions.
C. Labor or other expenses for the disconnection or return of the product for warranty ser vice, or for installation or reinstallation of the
product.
D. Accessories or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY SERVICE
Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Or, call Hansgrohe toll-free at (800) 334-0455.
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass
Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES
ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR
CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING
MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply
to you.
This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in
court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing,
always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions
at any time about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us at the toll-free
number and address printed above.
7
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004
Tel. 770 360-9880 • Fax 770 360 9887
www.hansgrohe-USA.com
Loading...