Factory Direct Hardware 10074001 User Manual

Installation / Warranty

Starck X

10074XX1

Starck X Wall Mount Lavatory Mixer

10074XX1

G ½

55°

700

Starck X

Starck X

Lavatory shown: Duravit Starck X 700

700

Technical Data

Flow rate 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120

*Many municipalities require that the water heater be set no higher than 120oF. Know and follow all
applicable local plumbing codes when setting the temperature on the water heater.

2

o

F - 140oF*

Prepare to install the faucet:

This faucet requires 2 1/2” female threaded fittings, spaced 3 1/8” apart (on center) for the hot and
cold supplies. For proper operation of the faucet, the hot supply should be to the left, the cold to the
right. The fittings should be recessed 3/8” behind the surface of the finished wall.

Finish and seal the wall before installing the faucet.
Your local plumbing codes may require supply stops for the hot and cold water supplies. These should

be installed in an easily accessible location.
Know and follow all applicable plumbing codes regarding the air gap between the end of the spout

and the flood level of the sink.
No drain is included with this faucet. Contact the manuacturer of your specific lavatory for recommen-

dations regarding a suitable drain.

Install the faucet:

• Seal the wall with a compatible, waterproof bathroom
sealant.

• Wrap the threads on the offset adapters with Teflon
tape. Install them to the hot and cold supplies.

TM

3