Faber MAES30SS Specsheet

Maestrale Pro

a professional performer

wall canopy rangehood

°

professional styling

°

Two chimney options

°

600 cfm Pro motor for 30, 36, 42”

°

1200 cfm Pro motor for 48”

°

3 halogen lights for 30”,36”,42”

°

4 halogen lights for 48”

°

3 speed slide control

°

stainless steel baffle filters

°

2 (30”), 3 (36,42”), 4 (48”) (filters)

°

top or direct rear venting

°

6” round duct for 30” & 36”

°

2 - 6” round ducts for 48”

°

Professional Collection

The new Maestrale range hood from
Faber is a professional hood with a
sense of style. With top or direct rear
venting and multiple chimney options
makes the Maestrale the most
versatile and easy to install Pro hood
on the market.

Size/Color/Model #

30 Stainless
36 Stainless
42 Stainless
48 Stainless

a

Telescopic Chimney Cover

24” wide, extends to accomodate 8 - 9 foot

c

ceilings

c

24 Stainless TELEMAES

e
s

Full Width Duct Cover

12” high, extends full width of the hood

s
o
r
i
e
s

p.o. box 435 • Wayland, MA 01778 • tel: [phone] • fax: [phone] • e-mail: [e-mail] • www.faberonline.com

30 Stainless
36 Stainless
42 Stainless
48 Stainless

Duct Transition Kit

For 48” model only, transitions two 6”
openings to one 10” round opening

Galvanized Steel

MAES30SS
MAES36SS
MAES42SS
MAES48SS

FULL30
FULL36
FULL42
FULL48

TRNSPRO

Replacement Charcoal Filters

For recirculating installations, high
quality, heavy duty filters ensure
the removal of smoke and odors
from the kitchen.

CFM Reducer Kit

For use in make up air environments where
an under 300 cfm hood is required. This kit
reduces the ducting to 5” round and re­duces the cfm to under 300.

USE WITH 48” size hood

NOT FOR

FILTER1

CFMRED

Dimensional Diagrams

WITH TELESCOPIC CHIMNEY KIT WITH FULL WIDTH DUCT COVER

Pre-Planning Your Ductwork - Important: Consult the installation instructions before you begin installing this rangehood.

The Maestrale can be vented to the top or directly out the

back. Make your ductrun as straight and short as possible.

The ductrun should not exceed 35 equivalent feet if ducted

with 6” round duct or 55 equivalent feet if ducted with 10”

round ductwork (for 48” model only). Count 45º angles as 3

feet, 90º elbows as 5 feet, and 90º flat elbows as 12 feet.

For best results, use no more than three 90° elbows. Make

sure that there is a minimum of 24” of straight duct

between elbows if more than one is used. Do not install

two elbows together. If you must elbow right away, do it

as far away from the hood’s exhaust opening as possible.

Rev.07/11

WARNING! Product specifications are subject to change without notification. Consult the installation instructions before you begin installing this rangehood.