Faber FZ-F128N, FZ-F128, FZ-F628N, FZ-F628 Instruction Manual
CHEST FREEZER
INSTRUCTION MANUAL
Please read this manual carefully,
and make sure to keep this manual
in the place accessible by a user at
any time .
Please read this manual carefully
1、 Name of Parts
1
2
3
4
5
1
2
3
4
5
1. Door 2. Cabinet 3. Temperature control front panel 4. Caster 5. Handle
2、Specifications:
Model
Temperature range (C)
Net
Weight
(kg)
External
Dimension
(WDH)
Refrigeration
Freezing
FZ-F128(N)
0~+10℃
≤-18℃
31
595570865
FZ-F628(N)
0~+10℃
≤-18℃
86
1855x740x850
Note: Design or specifications is subject to improvements without notice.
3、Portage and placement
1. In order to avoid trouble of the compressor or the system, the inclination of the unit can’t be over 45
o
during
transportation.
2. Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator etc.). Direct sunlight may affect
the acrylic coating and heat sources may increase electrical consumption.
3.Remove the exterior and interior packing before using. It is necessary we recommend to leave at least 100mm of space
between the back and sides of the unit, which allows the proper air circulation to cool the compressor.
4、Preparation
1. Be sure to ground the unit. Grounding can prevents electrical shock which would occurs when the electrical insulation of
the unit becomes insufficient.
2. Connect the unit to power supply having the rated frequency and rated voltage indicated on the rating label(220～240V,
frequency 50Hz), if the voltage is more fluctuant please use input power regulator upon 5 times alternating power.
3. Using the specified power socket with 3 holes and suitable fuse.
4. Hold the power supply plug not cord when pull out the power cord from the socket.
5. Never splash water on the unit directly. The wet unit may cause electric shock or short circuit.
6. Turn on the power 5 minutes later, after power turn off or stop running in order to protect the system and the compressor.
7. If longed power supply cord , connected cord area should more than 0.75mm2, cord is composed of one or more wire.
Don't connect with multifunctional power supply socket.
8.Turn the power on, turn the temperature control knob to 3～4 position, check the indicator light, compressor and
ventilating fan, after half an hour, temperature inside will cool down obviously, it means the unit working normally.
5、Temperatures controls adjustment and quick-freeze
1. Inside temperature can be adjusted through temperature control, the higher figure the lower temperature. The normal place
is between 3 and 4.
2. "1" refers to refrigeration point, storage temperature inside cabinet about 0℃, when food need quick-freeze, clockwise
turn the knob to "5", at this moment, the compressor will work continuously, after frozen, turn back the knob on the
Loading...